Laserfiche WebLink
San Joaquin County <br />Environmental Health Department <br />February 15, 2008 <br />600 East Main Street <br />Stockton, California 95202-3029 <br />Walton Engineering, Inc. <br />P.O. Box 1025 <br />West Sacramento, CA 95691 <br />Fax: (916) 373-1172 <br />Website: www.sjgov.org/ehd <br />Phone: (209) 468-3420 <br />Fax: (209) 464-0138 <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />Sent via Fax <br />Subject: Quik Stop #76,1030 S. Olive Ave, Stockton, CA 95215 (SR0053303) <br />The San Joaquin County Environmental Health Department (EHD) has completed the review of <br />the application for permit to perform an ISD/EVR phase II upgrade and cold start. The permit <br />has been approved with the following conditions. <br />Conditions of approval: <br />1. Contact the local fire department, local planning or building department and the San <br />Joaquin Valley Air Pollution Control District for any applicable permits. <br />2. Any changes shall be submitted to the San Joaquin County Environmental Health <br />Department (EHD) for approval prior to commencing work. All new addenda supercede <br />the previous ones. <br />3. All components must be certified by an independent testing organization and labeled as <br />required by the organization. (UL, ULC, ANSI, API, ASTM, etc. See California Code of <br />Regulations (CCR), Title 23 Chapter 16 Table B for complete list). The component must <br />bear the appropriate mark as required by the independent testing organization. <br />4. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all of the <br />following: <br />a. One of several permissible valid, current contractor's licenses issued by the <br />Contractors State License Board (may be issued to the installation company), and <br />b. All valid, current California UST certificates issued by the International Code <br />Council (ICC), that are applicable to the work being performed, and <br />c. A valid, current certificate of training from the manufacturer(s) of the <br />component(s) being tested, repaired, or serviced; <br />and <br />d. Each person installing or testing any component must hold a certificate of <br />training from the manufacturer of that component. <br />5. Before the alarm history is cleared by the "cold start", a current printout must be created <br />and available for EHD inspection. Inspection may occur during the functionality test. <br />Page 1 of 2 <br />