COMPLIANCE INFO_1985-1998 - Laserfiche WebLink

Home Browse Search

OPW 61SO-1000 and 61SO-100C Grooved Tube The OPW 6150-1000 and 6150-100C Overfill Prevention Valves feature a grooved tube design for use in two-point applications with tank gauging probes. The 61 SO -100C is CARB approved. These valves have a slotted section that runs through both the tube and the valve body to allow the installation of most manufacturer's gauging systems - with only a negligible effect on product delivery time. All OPW 61SO series valves are fur- nished with complete instructions and all of the necessary hardware for field or shop assembly. For complete assembly and installa- tion instructions, refer to C -3557 -PA (OPW 61SO and 61SOM) or C -3634 - PA (OPW 61SOC) or C -3687 -PA (OPW 61 SOP) or C -3792-M (OPW 61SOR). Materials Valve body: cast aluminum Float: nitrile rubber, closed cell foam Valve: aluminum Seals: viton Upper & lower Drop Tube: aluminum Plastic parts: Acetal Hardware: Stainless Steel Replacement Parts Part No. Description 61 SOK-0001 Float Kit C03899M Two point inlet tube C03632M Coaxial inlet tube Important In order to prevent product spillage from the Underground Storage Tank (UST), properly maintained delivery equipment and a proper connection at the tight fill adaptor are essential. Delivery personnel should be managed and trained to inspect delivery elbows and hoses for damaged and missing parts. They should always make certain there is a positive connection between the adaptor and elbow. If delivery equipment is not properly maintained, or the elbow is not securely coupled to the adaptor - a serious spill may result when the OPW 61 SO closes - causing a hazard, and environmental contamina- tion. Note: The OPW 6150 Overfill Prevention Valve is not to be used in pumping applications. The 61SO is designed only for tight fill, gravity drop applications. Information For additional useful information on the specification, assembly, installation and use of the OPW 61SO, refer to Technical Bulletin TB -6150. OPW 61 SO Overfill Prevention Valves are covered under the following patent: 4,986,320. Re 33,555 and Canadian patent 1,287,546. Other patents pending. IMPORTANT. OPW products should be used in compliance with applicable federal, state and local laws and regulations. Product selection should be based on physical specifications and limitations and compatibility with the environment and materials to be handled. OPW MAKES NO WARRANTY OF FITNESS FOR A PARTICULAR USE. All illustrations and specifications in this literature are based on the latest product information available at the time of publication. OPW reserves the right to make changes at any time in prices, materials, specifications and models and to discontinue models without notice or obligation. EP 19.0