Laserfiche WebLink
site Address: 4344 WATERLOO RD <br />D. Results of Testing/Servicing <br />Software Version Installed: 16.01 <br />Complete the following checklist: <br />onitoring System Certification <br />Date of Testing/Service: 03/14/2002 <br />❑ Yes <br />[� No* <br />Is the audible alarm operational? <br />❑ Yes <br />® No* <br />Is the visual alarm operational? <br />M Yes <br />❑ No * <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not <br />Yes <br />❑ No <br />interfere with their proper operation? <br />Yes <br />❑ No * <br />N/A <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />Yes <br />❑ No * <br />❑ N/A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive <br />shut -down? (check all that apply) [n Sump/Trench Sensors; ® Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? [N Yes E] No <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e.: no mechanical <br />Y <br />E] Yes <br />❑ No * <br />NIA <br />❑ <br />overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill points(s) and operating <br />properly? If so, at what percent of tank capacity does the alarm trigger? % <br />Yes* <br />® No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br />❑ <br />manufacturer name and model for all replacement parts in Section E, below. <br />® Yes* <br />® No <br />Was liquid found inside any secondary containment systems designed as dry systems? (check all that apply) ❑ Product; <br />❑ Water. If yes, describe causes in Section E, blow. <br />® Yes <br />❑ No * <br />W1 monitoring system set-up reviewed to ensure proper settings? Attach set-up reports, if applicable. <br />® Yes <br />❑ No* <br />is all monitoring equipment operational per manufacturers' specifications? <br />* in Section E blow, describe how and when these deficiences were or will be corrected. <br />E. Comments: <br />page 2 of 3 <br />