COMPLIANCE INFO_2004-2006 - Laserfiche WebLink

Home Browse Search

2). LUBRICATE clamp bolt thread_s and clamp tongue with WD 40 or light machine oil. Do not lubricate inside of pipe or outside barbed section of termination fittings !. 3).For 1.5 inch ID Direct Connection fittings, initial band clamp torque set is 12 foot pounds (144 inch Pounds) For 2.0 inch ID it is 20 foot pounds.(240 inch pounds) NOTE: Tighten clamp nearest pipe termination fitting first. Prior to testing and after all clamps have been torqued, re-check all torque settings. Please call Western Fiberglass for additional or cold weather instructions. CAUTION; USE ONLY WESTERN FIBERGLASS,INC. APPROVED TERMINATIONS. INSTALLING PIPE LENGTHS: Crossover Supports may be installed over Direct Bury Co-Flex piping to prevent any chafing where two pipe runs cross. After test/crossover boots, and if required crossover supports, have been installed and if used, pipe termination has been swaged on, insert pipe through pipe penetration boots one side at time. Remove penetration hose clamp or loosen first for ease of installation. If using the Direct Connection termination fittings, install pipe into penetration first, prior to clamping of fitting end. Prepare coupling fitting threads and attach Co-Flex termination fitting (male or female) to connector/s or Direct Connection fitting and clamps within sump area/s. Tighten to specs. Position pipe within trench for proper spacing. Lay out piping runs while maintaining separation between pipe lengths and at crossover points. TEST & CROSSOVER BOOTfrUBING INSTALLATION: The Test/Crossover Assembly Boots are attached to the Co-Flex Piping ends to provide a sealed communication access and test point for the interstitial/secondary space within the pipe. The Test/Crossover Boots utilizes two (2) stainless steel band clamps which when tightened around the primary or inner pipe jacket and the Co-Flex containment outer jacket isolate the interstitial space.