COMPLIANCE INFO_2007-2012 - Laserfiche WebLink

Home Browse Search

SWRCB, January 2002 Page _5_ of —5- 8. FILL RISER CONTAINMENT SUMP TESTING Facility is Not Equipped With Fill Riser Containment Sumps Fill Riser Containment Sumps are Present, but were Not Tested Test Method Developed By: Sump Manufacturer Other (Specify) ® Industry Standard Professional Engineer Test Method Used: Pressure Other (Specify) Vacuum ® Hydrostatic Test Equipment Used: INCON TS -STS UNIT Equipment Resolution: N/A Sump Diameter: Fill Sump # DIESEL 38" Fill Sump # Fill Sump # Fill Sump # Sum De the 45" Height from Tank Top to Top of Highest Piping Penetration: N/A Height from Tank Top to Lowest Electrical Penetration: 26" Condition of sump prior to testing: GOOD Portion of Sump Tested 2" ABOVE TANK/SUMP COLLAR Sump Material: FIBERGLASS Wait time between applying pressure/vacuum/water and starting test: 15 MINUTES Test Start Time: 10:06 10:22 Initial Reading (Rj): 3.8700 3.8200 Test End Time: 10:21 10:37 Final Reading (RF): 3.8700 3.8707 Test Duration: 15 MIN 15 MIN Change in Reading (RF -R,): .0000 .0007 Pass/Fail Threshold or Criteria: .002 .002 Test Result: ' ® Pass Fail Pass Fail Pass Fail Pass Fail Is there a sensor in the sump? ® Yes No Yes No Yes No Yes No Does the sensor alarm when either product or water is detected? ® Yes No NA Yes No NA Yes No NA Yes No NA Was sensor removed for testing? ® Yes No NA Yes No NA Yes No NA Yes No NA Was sensor properly replaced and verified functional after testing? ® Yes No NA Yes No NA Yes No NA Yes No NA Comments — (include information on repairs made prior to testing, and recommended follow-up for failed tests) *Fill Sump pass the industry standard hydrostatic test. No repairs are needed at present time.