Laserfiche WebLink
Sent By: CPE USALCO; <br />I-MEMDRFAU• <br />KAUM <br />AW ELEMONIC3 <br />916 372 0941; Mar -12-01 16:42; Page 4/7 <br />The Model 404 Pump Cut -Off is a solid state two-part modular system that was specifically <br />designed for use in containment /sumps for dispensers and turbines. The system <br />functions as a passive device for monitoring an accumulation of fuel spills and/or filter <br />leaks. When this accumulation reaches a user specified level, the dispenser or turbine is <br />shut down until the sensor is reset. <br />• The intrinsically safe sensing probe actuates whenever the level of the accumulating liquid <br />reaches a factory preset level of approximately 3/8" water column. <br />+ The controller, which also provides an intrinsically safe barrier, is connected to the dis- <br />penser or turbine junction box and operates on either 120 or 240 volts. The controller is fully <br />encapsulated and is approved for use in Glass 1, Group D environments. The unit is capable <br />of handling up to 20 amps of electrical load. <br />• The system is easily installed and is connected to EXISTING wiring at the dispenser or tur- <br />bine location, eliminating the need of pulling new wires or breaking concrete. <br />• Additional sensing probes may be ordered for use in multiple compartment containment <br />pans. These probes are available as a Model 404A kit and come complete with a cable <br />splitter. <br />+ BEPs impact sensor is also compatible with the Model 404. The impact sensor kit is a <br />Model 408A and also comes with a cable splitter, <br />The Model 404 and accessories are thUd party tested and approved by ETL. <br />The Model 404 pump cut-off system is patent pending. <br />