Laserfiche WebLink
UST <br />SYSTEM DRAWING INFORMATION <br />1. <br />V <br />Three complete sets of plans (include marnifacturer's specification sheets for proposed equipment to be installed). <br />2. <br />9 <br />Plans drawn to scale in non -erasable print. <br />CAPACITY IIV &ALL04.5 <br />4-®`31007✓�d�J <br />3. <br />7,7 <br />Plot plan to show location of tanks and all associated piping. <br />4. <br />MANUFACTURER <br />COMPOSITION <br />Striker plates or drop tube -mounted bottom protectors illustrated below all accessible openings. <br />5.V <br />MODEL <br />Tank cross-sectional diagram. <br />6. <br />V/ <br />Detail of tank, associated piping, excavation and cover. <br />7. <br />✓ <br />Tank(s) and piping approved by a nationally recognized inddpendent testing organization. [Title 23, Chapter 16, <br />CORROSION PROTECTION <br />Article 3, Section 2631 (b) & 26353 <br />g, <br />Verification of product compatibility with the tank(s), piping, monitoring <br />�/ <br />device(s), epoxy or silicone glues, etc. <br />9, <br />V/ <br />Manufacturer's written installation instructions for tank(s), piping, monitoring devices, etc. <br />10. <br />At the installation site, prior to installation, a tightness test shall be performed on both primary (10) and <br />secondary (2°) containment systems before covering. [Section 2635 (a) (3) & (4)3 <br />/ <br />11, <br />v <br />Tank integrity test required upon completion of installation with tank in operating condition. Test results to be <br />submitted directly to PHS-EHD from the testing company or owner of facility. [Health & Safety Code, Division 20, <br />Chapter 6.7, Section 25291 (h)] <br />16. Iwwk wnrwa aa+n <br />TANK 9 <br />9 <br /># <br />CAPACITY IIV &ALL04.5 <br />4-®`31007✓�d�J <br />J Z/�[ <br />�G.� <br />MANUFACTURER <br />COMPOSITION <br />g'fL�i~ L FX:P <br />s <br />MODEL <br />l SV PC:X7A4k. I <br />PRODUCTj�l <br />{j L®►C'�SFL <br />UNL�i406 <br />CORROSION PROTECTION <br />i�- 7 <br />U.L. LISTED <br />COMPATIBILITY WITH 100x <br />METHANOL <br />13. TANK(s) TO BE INSTALLED <br />A. Steel -clad with fiberglass reinforced plastic coatings, composites, or equivalent non-metaltic exterior <br />coatings or coverings. <br />(1) <br />7 (2) <br />B. Fiberglass <br />(1) <br />Tested at the installation site using an electric resistance holiday detector. <br />Vacuum applied to interstitial space. <br />Installation instructions require an air test and soap bubble test prior to installation. <br />(2) Vacuum applied to interstitial space. <br />(3) Hydrostatic annutar (primary tank pressure test). <br />_ C. Non -clad steel tank [Section 2635 (a) (2) (A)] <br />_ (1) Cathodic protection provided for entire tank, piping and components (nuts, bolts, washers <br />etc.). <br />_ C2) Field installed cathodic protection systems designed and certified as adequate by a <br />corrosion specialist. <br />(3) Impressed current systems to be inspected no less than every 60 days. <br />5 <br />