Laserfiche WebLink
14 <br />15 <br />N -A <br />p. Alternate const ion for new underground storage tanks c ing motor vehicles fuel (Section 26333. <br />(1) Monitoring and response plan (Section 26343. <br />(2) Underground storage tank composed of.... <br />(a) fiberglass reinforced plastic. <br />(b) Cathodically protected steel. <br />(c) Steel clad with fiberglass reinforced plastic. <br />(d) Other material that complies with section 2631 and 2632. <br />(3) Floor of leak interception and detection system constructed on a firm base and sloped to a <br />collection sump (use of membrane liners comply with section 2631 (d) (6) requirements.) <br />_ (4) Access casings installed in the collection sump of the secondary containment system with <br />backfill in the interstitial space. The access casing shall meet all of the following: <br />Designed and installed to allow the liquid to flow into the casing. <br />_ Sized to allow removal of collected liquid and able to withstand all anticipated applied <br />stresses. <br />Constructed of material that will not be structurally weakened. <br />Screened along entire vertical zone of permeable material. <br />Capable of preventing leakage of any hazardous substance from the casing. <br />Extend to the ground surface and covered with a locked waterproof cap. <br />Capable of meeting S.J. Co. PHS -END Nell Standards. <br />Leak interception and detection system shall prevent the leaked hazardous substance from <br />entering ground water. <br />INTERSTITIAL SPACE MONITORING <br />A. <br />visual monitoring [Section 2632 (c) (1)3 <br />(a) <br />Exterior surface and floor beneath tank monitored by direct viewing <br />(b) <br />Daily visual inspections <br />_ <br />(c) <br />Liquid level in tank to be recorded at time of inspection <br />(d) <br />If liquid observed around or beneath primary tank, owner will determine if an unauthorized release <br />_ <br />has occurred. <br />8. <br />Mechanical or electronic monitoring [Section 2632 (c) (2)3 <br />(a) <br />Continuous monitoring system connected to an audible and visual alarm system. <br />Monitoring equipment to be installed <br />_ Manufacturer: 41 1 (,64AC O <br />_ Model Number:_ iEMC,_WU2 P <br />Sensor Type: Vapor liquid Both. <br />Sensor/Panel specifications. <br />_ Location(s) for sensors: SUMPS Tank: I M2S-[47iAL Piping: <br />sGoPE $PrGK- 'r0 -5y P.5 . CW l <br />_Dispenser: <br />C. <br />Monitoring <br />and response plan submitted [Section 2632 (d) (1) & (2)3. <br />Any special <br />accessories, fittings, coatings, or linings not inherent within the initial design of the 1° tank or <br />_ <br />doubts -watt <br />UST. [Section 2631 (b)] <br />• <br />A. <br />Approved by a nationally recognized independent testing organization. <br />a. <br />Demonstration of integrity with the primary and/or secondary containment. <br />1.1 <br />