Laserfiche WebLink
1 i <br /> �_, <br /> ' Page 6 of 8 orr <br /> 8. FILL RISER CONTAINMENT SUMP TESTING <br /> Facility is Not Equipped With Fill Riser Containment Sumps ❑ <br /> Fill Riser Containment Sumps are Present,but were Not Tested ❑ <br /> Test Method Developed By: ❑Sump Manufacturer ❑Industry Standard ❑Professional Engineer <br /> ❑Other(Specify) <br /> Test Method Used: ❑Pressure ❑Vacuum ❑ Hydrostatic <br /> ❑Other(Specify) <br /> Test Equipment Used: Equipment Resolution: <br /> Fill Sump # Fill Sump# Fill Sump # Fill Sump # <br /> 7from <br /> op to Top of <br /> Highest Piping Penetration: <br /> Height from Tank Top to Lowest <br /> Electrical Penetration: <br /> Condition of sump prior to testing: <br /> Portion of Sump Tested <br /> Sump Material: <br /> Wait time between applying <br /> pressure/vacuum/water and starting <br /> test: <br /> Test Start Time: <br /> Initial Reading Ri): <br /> Test End Time: <br /> Final Reading(RF): <br /> Test Duration: <br /> Chane in Reading RF-Ri: <br /> Pass/Fail Threshold or Criteria: <br /> TestResuR: ❑ Pass ❑Fait R-Pass ❑Fait ❑ Pass ❑ Fail Q PassL3,1740 <br /> Is there a sensor in the sump? ❑Yes ❑ No ❑Yes ❑ No ❑Yes ❑ No ❑Yes ❑ No <br /> Does the sensor alarm when either ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑ NA ❑Yes ❑No ❑NA <br /> product or water is detected? <br /> Was sensor removed for testing? ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA <br /> Was sensor properly replaced after ❑Yes ❑ No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA <br /> testing? <br /> Comments—(include information on repairs made prior to testing and recommended follow-up for failed tests) <br />