Laserfiche WebLink
STEP I Identify the damaged boot and select the proper Blueline Repair <br /> Boot based upon the number of studs and the pipe OD.(See 2006 <br /> Catalog,Section 10 and Appendix 1) <br /> - A ML**A,- <br /> STEP 2 Install all Pellethane split components onto the pipe carefully.All <br /> Pellethane pieces must be rebonded back together with Blue Sea] <br /> Glue.This is done by ensuring that the surfaces are clean and dry. <br /> Apply a liberal bead of Blue Seal and hold the seam closed <br /> securely until it is fused. It's helpful to use the clamps to loosely <br /> hold the boot closed during curing. Bonded connections should <br /> hold themselves closed within rive minutes if there are no stresses <br /> on them.The Blue Seal glue will be fully cured in 40 minutes. <br /> STEP 3 Once all Blueline approved components are bonded, apply a <br /> liberal bead of either Parasealaut 626, or Bostik 1100FS to the <br /> underside of the seal.This will make the seal with the sump wall. 1 4 <br /> Insert poly ring Into the gasket and position the ring around the <br /> old fitting and against the sump wall. <br /> STEP 4 Install the self tapping tek screws through the holes in the poly <br /> ring and tighten until snug.(Be careful not to over tighten as the <br /> holes can be easily stripped out.) 16 <br /> STEP 5 Apply a bead of Blue Seal Glue along the gasket rim and install <br /> the boot onto the seal. Install boot with fill tube at the 12:00 <br /> position.Install band clamp to secure the boot to the gasket <br />