Laserfiche WebLink
e e e <br /> STEP 6 Position the insert into the boot if applicable,but do not tighten <br /> the clamp.This connection must remain loose through the filling <br /> stage to allow air to escape. <br /> y �® <br /> STEP 7 Fill the boot with either Parasealant 626, or Bostik 1100FS <br /> through the fill tube with the Blueline pneumatic dispensing gun "® <br /> `pushuntil the entire cavity is full. This will ensure that the sealant 116— <br /> pushes <br /> es back through the leak point and stops the leak. <br /> l <br /> STEP 8 Once the boot is full, tighten clamps and allow sealant to fully <br /> cure.The sealant will gradually continue to cure up inside the .,. <br /> boot and around the flange over the next 24-48 hours.However, <br /> you may start hydrostatic testing immediately as the repair is ; <br /> complete. j <br /> •e e e e a • e a <br />