COMPLIANCE INFO_2011-2015 - Laserfiche WebLink

Home Browse Search

C - WATER TESTING SUMP / FITTINGS It is recommended that all piping and conduits be connected at this time. Clear all debris & materials from the transition sump. All field installed penetration fittings must be water -leak tested. CA- To test field installed fittings, add enough backfill under the Transition Sump so its weight is completely supported. Do not allow island supports to hold all the weight. The box will become extremely heavy. C.2- Fill the box with water to 2 inches above the highest fitting. After 3 hours, make a visual inspection of the exterior of the box. If there are no leaks, proceed to remove the water with an appropriate pump. DO NOT DRILL A DRAIN HOLE, and plan to patch the hole. If there ARE leaks, proceed to Step D (below) for repair instructions. D - IF ANY LEAKS ARE FOUND! ! A: Locate leak point(s) and mark with marker so you can locate it / monitor it. B: Repair or reinstall penetration fittings according to your penetration fitting manufacturers' Installation / Maintenance Instructions. C: Occasionally... Bravo Fiberglass Series Products may suffer mild damage in transit or field installation. Please take a close look at edges and corners. D: FOR FIBERGLASS REPAIRS: Abrade a 3" diameter area centered on the leak point until flow coat is gone and natural resin/fiberglass material can be seen. Dust with shop brush or compressed air and do not use shop towels or acetone. S. Bravo Systems recommends "Smith Fibercast Adhesive Kit #8014" to repair and reinforce Bravo Fiberglass products. Make sure area is completely dry and apply resin generously. For anything larger than pinhole leaks you must consult the factory. FOR PENETRATION FITTING LEAKS/REPAIRS: Follow penetration fitting manufacturers repair recommendations in their respective Installation Instructions. DO NOT compromise Bravo Product Integrity. E: Let cure for a minimum of 2 hours @ or above 75° Fahrenheit. 4 ii -B500/600 -SW -08B