COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

Figure 2 drain valve passes testing no further maintenances required. If the drain valve fails testing, remove the Step 8: (See Figure 3&4) valve, soak in water and use high-pressure air, if Install adjusting system beneath tabs on mounting needed, to clean. Reinstall the drain valve to its ring. See Figure 3 for standard cover models. See proper position and test the valve with CARB Figure 4 for sealable cover models. Add shims as procedure TP-201.1 C or TP-201.1 D. If problems needed and adjust with screw. (Shims must be cut persist, replace the drain valve with P/N 1 DK-2100- to size for sealable cover models.) The height can EVR (specified torque 11.5 ft-lbs min to 13.5 ft-lbs be increased up to 1"(2.5cm). max, 5/16-18 UN thread). The sealable cover(1SC) Note: The adjustment should not be more than 1" adjustment nut is set at the factory, but due to from the initial length of the unit. environmental conditions it may be necessary to adjust it to either improve sealing or ease cover Step 9: removal. Upon preliminary installation perform the California Test Procedures TP-201.1C or equivalent. Their terator. portant: Leave these instructions with Station Test Procedures will check the seals between the drain valve, nipple and rotatable adapter. To test the spill containers base and bellows fill the container with water. A drop in the water level of 1/16" or greater after one hour means that a leak exists. To determine where the leak is, look for a steady stream of bubbles coming from one of the joints or water leaking on the outside of the bucket. NOTE: Do not drain the water into the UST after the ° =7._.C_. ° test is complete. Water must be disposed of per Height _--__-__- Shims Adjustment Bolt local requirements for hazardous waste. If the leak cannot be corrected the spill container should be ------------ replaced with another. Adapter --...... Cap Step 10: (See Figure 2) Figure 3-Standard Cover Model Height Adjustment Before pouring concrete, place plastic over the cover and mounting ring protecting them from concrete splash. Double check that the unit is level and at proper grade height. Pour concrete per figure 2. Ramp or dome the concrete away from the mounting ring. There should be a minimum of 1" slope to finish grade. The concrete surface should start at the bottom edge of the watershed slots and tapered down to grade level. NOTE:Do not stand on spill container before concrete sets up. Remove plastic from cover after concrete has dried. Shims Must TM Remove adjustment system. Adaptor and tight fill Be Cut To HeightLength Adjustment cap can now be installed in sealable cover models. Boit Re-test the spill containers for leaks as described in step 9, after the concrete has set up. Use oPw 116-7085 or 4"Pipe Cap Operation and Maintenance: to Support Nipple Annually: Inspect and clean the interior of the spill Adjustment container and drain valve screen. Remove System accumulated dirt and grit. Test the drain valve using Figure 4-Sealable Cover Model height adjustment CARB procedure TP-201.1C or TP-201.1 D. If the REQ" E C� c\'� > 0 2020 ENVIRONMENTAL HEALTH 4 DEPARTMENT