COMPLIANCE INFO_2004-2009 - Laserfiche WebLink

Home Browse Search

Note: Fiberglass alignment rings can only be bonded to a flat fiberglass sur- face. DO NOT install on round sumps. i. Determine entry hole location and cut entry hole in sump wall using dimensions in Table i. (Maximum allowable offset is 5".) TABLE 9. Fitting Dimensions Size A B C {in.) (n.) (in.) (n) 3x2 6.83 4.00 4.00 4x3 6.83 4.00 6.00 Bulletin No. B2108 October 1, 2004 Sump EntryfTermination Fitting with Bonded Fiberglass +e:- Alignment 2. Using 4o -6o grit sanding surface, sand the area around the hole where the alignment rings will bond to the sump. Lightly sand the rings. Remove dust and wipe with solvent (optional). 3. Place two alignment rings on sump entry/termination fitting and insert through sump wall with the rings on the outside of the wall. Locate the 114" threaded outlet to the desired location. Leave 1/4" plastic threaded outlet protector in place until 1/4" fitting installation. 4. Dry, fit primary pipe and rotate the two rings until the desired angle is reached. Make alignment marks on the rings and the sump wall. Er"fFerminabon Fitting Body Sump Wall Alignment Rings Outside Sump C Inside Sump Hole) Dia I to, 1 � F—B Retaining Ring A 5. Place one ring over the sump fitting in the inside of the sump and rotate to the desired angle. Make align- ment mark on both the sump wall and the ring. 6. Mix one 7014 or Soi4 adhesive for each fitting per the instructions in the adhesive kit Mix in filler to thicken adhesive (fiberglass alignment ring will not seal properly without filler). 7 Apply adhesive generous- ly, approalmately 1/i6" thick to the inside and the (OV-) URL htto://wwN-,rr hfiberc=.com FIRFR M aec crcTF TN FIRF;Zr AqT ritVISIiMf . e VAPM MIAPANY