COMPLIANCE INFO_1995-2006 - Laserfiche WebLink

Home Browse Search

FROM': WILLIAMS FAX NO. : 9167140059 Feb. 02 2004 02:01PM P6 Installation instructions Double Entry !Boots Double Entry Boots These two-piece rubber boots are designed to seal pipe and conduit entries both inside and outside the containment chamber. The inner band clamp seals the pipe or conduit entry while the outer band clamp provides additional haling against aggressive backfill conditions such as those present in high water areas. As with all entry boots,the recommended hole saw sizes must be used for proper installation. Step#1 Step 92 Locate the center entry point in Drill out the entry loot open- the flat wall section of the sump Ing by using the appropriate base and drill a 5116"hole.Install size hole saw. After drilling the Entry Soot Template to the out opening,clean any rough sump base wall using a 1/4"bolt edges with a razor knife or and nut Drill out ono hole of deburing tool. the appropriate bolt hole circle for the size boot to be installed Hole Saw Double Entry Boots using the same 5116"drill bit. 2-3/8" DEB-3050,=5,3100 Insert a second 1/4"bolt and 41/4" DEB-6150,6200 nut through this hole to secure 5-1/2" DEB-7360,7400 the template. Continue to drill the remaining holes of the bolt hole pattern. After drilling, remove the template from the sump base wan. step#3 p Step#4 t9 i Install the outer component of t Using a 7116"nut driver,tightenP i the entry boot from outside the all of the nuts evenly and firmly. sump by inserting the studs To prevent deforming boots, through the bolt holes. From do not over tighten nuts. If a the inside of the sump,install torque wrench is used,the set- the inner component of the ting should be 60 in.lbs. boot,compression ring and nuts as shown. 0 1 Step#{5 step#s vo When sealing 1.1/2"GeoFlex Insert the pipe or conduit into Piping,slip the appropriate Rub- the entry boot from outside of • ber Reducer Donut on to the the sump. Align the Rubber piping as shown. Reducer Donut(if required) flush with the outer edge of the • 1.1/2 GeoFlex-S RRD-2015-$ outer component of the Entry Boot as shown. For Coax Fit- * 1-1/2 GeoFlex-D RRO-7015-D tings,install a second Rubber Reducer Donut over the lou. pling and align with the front edge of the entry boot. Tighten the inner band clamp to 30 in.lbs. Tighten the outer band clamp to 30 in.Itw. WARNING IMPORTANT Keep all fiberglass cleaning solvents away from boots. The recommended hole saw size must always be used aa These types of solvents could cause severe damage. for proper imsllatan of the duct le Entry Boot and to main- fain the product warranty. Environ Products,Inc. ® P.O.Box 330 • Smithfield,NC 27577.0330 • TeI:(919)359,UOO a fax;(919)359-3687 Customer Service:(840)833-1883 • www,envproduct.com• 0 Copyright 2001