Laserfiche WebLink
i <br /> MORE <br /> ' II 1 <br /> EM11M <br /> M-14- <br /> STEP7 .Apply a bead of Blue Bond 801 around the housing threads �`• `a, <br /> and thread the repair boot onto the housing. <br /> STEP 8 Index the repair boot with the fill tube at the 12:00 position. <br /> OR <br /> NOW <br /> STEP 9 Install the split insert around the pipe and apply a liberal ` <br /> i. � . .,. ' <br /> bead of Blue Seal Glue along the seam and lightly hold or f, <br /> clamp until cured. •'j'+ ;'; . ' ':.; <br /> �%•""'v�`��':;ems.i�y�.1. <br /> =- <br /> STEP 10 Install the insert into the repair boot. <br /> STEP 11 Install the rear clamp and tighten to 65 inch lbs. (Be careful <br /> not to do this until the Blue Bond 801 is cured.) Install the ;•,.;;_, �r;,: _ <br /> outer clamp loosely so that air can escape between the insert <br /> and the boot while the boot is being filled with Bostik sealant. <br /> Fill the entire boot cavity with Bostic: 1100FS sealant. As the <br /> boot fills it will begin to pressurize and push the insert <br /> ourivard. <br /> STEP 12 Tigliten the outer clamp to 65 inch lbs. Clean up any excess <br /> sealant and allow 24-48 hours for Bostik 110OFS sealant to <br /> fully cure. <br /> li(1.fps <br /> MV NO= <br /> NEW <br />