Laserfiche WebLink
File MH28727 Vol. 1 Sec. 1 ILL-lA(Page 1) Issued: 2004-01-05 <br /> And Report <br /> ti7'EP 1 Identify the damaged hoot and select the proper Blueline Repair <br /> Boni britt!upon the ntunber of studs and the pipe Ol).(See 2006 <br /> Catalog,St-conn 10 and Appcndiz I) <br /> i� <br /> t <br /> If P! <br /> IOD <br /> ti!'EI'2 Remove band clamps from ok1 fitting. Remove the nuts from the <br /> cc <br /> stubs and store for future use.Remove.old fitting.The old fitting <br /> will need to be cut off.Take care not at damage the secondary <br /> pipe. Oe <br /> I <br /> STEP Install all Pellethane split components onto the pipe carefully.:!!! <br /> Peifethane pieces must be rebonded back together wide Blue Sea) <br /> Glue,This is done by ensuring that the surfaces are dean and dry. <br /> Apply a liberal bead of Blue Seal and hold the sears closed <br /> securely until It Is fused.It's helpful to use the clamps to loosely <br /> hold the boot closed during wring. Bonded connections should AN. <br /> h44themselves closed within five minutes if there are no stre ses <br /> tm them.The Blue Seal glue will he fully curet!in 40 minutes. <br /> S'l Ell Once all components are bonded,apply a liberal head of AWOR <br /> t <br /> Bostik 118OFS to the underside of the seal. l` <br /> This will make the seal with the sump well. Insert poly ring into <br /> the gasket and position it onto the studs and up against the suatp 1`\ <br /> wall <br /> 1 4D <br /> STEP 5 Reinstai)nuns and tighten theta in a star pattern. <br /> ,:x::::11 <br /> 0060438298 <br />