Laserfiche WebLink
' File' MY28727 Vol . 1 Sec. 1 ILL-1B(Page 1) Issued: 2004-01-05 <br /> And Report <br /> STEP 1 Identlfy the doniaged boot and select lie proper Blurkite.Repair <br /> Hoot bayed upon the number of studs and the pita.pp-(See 21)06 <br /> ('ata log,Section 10 and Appendix 1) <br /> Silt... <br /> STET 2 Install no Pellethane spin coul"wnts onto the pipe carefully.All <br /> Ptlltthane pieces must be rebonded back togcthtr with[out seal <br /> Glut.This is done by ensuring that the surfaces are clean and dry-. q <br /> Apply a liberal bead of Blue Seal and hold the scant closed <br /> securtly until it!s fused. It's helpful to use the cLtnps to loosely _ <br /> hold the boot closed during coving. Bonded connections should <br /> hold themst4ves closed within five minutes if there are no stresses <br /> on them.The Blue Seal glue wl)l be full•eared in 40 minutes. - <br /> 5['EP3 Once all 111ueline approved coo _ <br /> Iibtral bead of ponrnts are bonded, apply e — <br /> ikrteik 110-OPS to the <br /> underside of the sea!This WW make the.seal with the swap stall. <br /> Insert poly ring into the gasket and position the ring around the <br /> old fitting and against the sump wall. <br /> STE1'a Install tht stif tapping tek scrtA3 through the hi k-4 in the poly <br /> ring and tighten until Mulb(Be carefulIM4 to oder tighten as the ' <br /> Wes can be easily stripped out) ' <br /> �— ra <br /> R <br /> Sl'f P 5 .A'pply a bead of Illue Still Clue along the gasket rim and install <br /> Ow hoot onto the seal. 'natal' hoot with fill tube at the 12:00 <br /> position.Install band clsttrp to secure the boot to the gasket. <br /> MIN <br /> C060438299 <br />