COMPLIANCE INFO_2002-2005 - Laserfiche WebLink

Home Browse Search

POMECO Multi-Port Spill Container Manhole 3. Remove the cover and measure the distance Installation Instructions from the top of the tanks to the final grade. 1. Mark off finish grade. (See Figure 1.) 4. Cut the riser(s)from the underground tank so that both the fill and vapor risers are set below Finish Grade the final grade. Use the dimensions below: Spill Container Inches below grade(L) 5 Gal.Cast Iron Base . 181/20 5 Gal.Composite Base 195/81, Figure 1 7.5 Gal.Cast Iron Base 22Y2* 7.5 Gal.Composite Base 23 5/8" 'Note., Add an extra 3-114"when usfng an OPW 2. Set multi-port manhole assembly(skirt,ring,and FSA-400 Face Seal Adapts: (See fture 2.) cover}to the final grade position. (See Figure (Offset add extra 6") 2•) 5. Debun'and thoroughly dean riser pipe(s). Finish Grade 6. Apply pipe dope to riser(s). The pipe dope is.to be a non-hardening,gasoline resistant, pipe thread seal compound. 7. Install OPW FSA-400 Face Seal Adapter onto user. (Recommend Torque,4"NPT, 125 ft4bs min.to 250 ft4bs max.). Apply pipe dope to FSA-400. The pipe dope is to be a non- hardening,gasoline resistant, pipe thread seal compound. This is optional for spill containers that are on the vapor lines. 8. Thread on spill containers 9. Using the 61 SA TOOL,tighten the spin container(s)onto the riser(s)with a minimum Figure 2 torque of 125 it.-lbs.and a maximum torque of 250 itAbs. Note: it is strongly recommended that POMECO Note: Do NOT attempt to completely tighten the covers be installed with the following minimum containment bucket by using the containment clearances. Sheet metal skirts should have bucket mounting ring at the top of the bucket. adequate clearance between the tank sump riser 10. Inspect the containment bucket O-Rings and sidewali and or the sump top hat. A minimum of Mounting Ring 0-Rings;for damage. Replace one and a half inches clearance on all sides is the gasket(s)if they are damaged. recommended between the POMECO skirt and 11. Install Optional Multi-Port Water Shroud the tank sump wall or the sump top hat wail. A (MPWS).See separate instructions. minimum of two inches clearance is 12. Remove Spill Container Cover and Sp11 recommended between the bottom of the Container Mounting ring from Manhole Cover. POMECO skirt and the horizontal surface of the 13. Replace the multi-port cover,centering the tank sump or sump top hat These clearances riser(s)as dose as possible in the containment are recommended to allow adequate water openings. Be very careful not to move or migration away from the sumps. Great care damage the 0-Rings. should be used to maintain the recommended 14. Remove lock washers and nuts from the clearances when setting the rings and pouring studded mounting ring. the concrete. (See Figure 3.) 1%s Min N Figure 3