COMPLIANCE INFO_2002-2005 - Laserfiche WebLink

Home Browse Search

15. Place the mounting ring over the containment the ring and improper fit of the ring to cover after ! buckets and rotate the mounting ring until the the concrete is poured. studs are aligned with the bucket ring holes. 21. When pouring the concrete,hand shovel or (See Figure 4.) trowel the concrete around the mufti-port assembly to prevent the unit from moving or shifting,which can cause afign ment problems and future maintenance problems. smaaea Note: Do not stand on the multi-port before the M--Aio6 RiaS concrete has setup. 22: It is recommended that the paved contours around POME+CO covers be-adequately ate to died water flow away from the cover;and 63 . directing water runoff from adjacent areas away.. o x; c from POMECO covers. (See Figure T.) Figure 4 16.Thread nut and lock washer onto studded mounting ring.Tighten the mounting ring retaining bolts until the containment bucket o-rings makes contact with the mufti-port cover. Figure T :Then,:in a c rossing,pattem,torque the bolts down +err 1b.10 20 it-lbs}6 PokTisbox < e Remove. .. to set MO plastic.after die MM.M Ofich (See Figure 5.) up.. - 24. After installation is complete,water test the mufti-port fixture. The recommended water test procedures include: a) Spraying water on cover(s)for 5 to 10 N%d&W minutes,using a commonly available reckw&sb" watering device such as a lawn sprinkler. b) Standing water test,not to exceed V in : waterd".for a period of 5 to 10 minutes. Tho-contaiiirttent bucket consists of three components cast iron ring,bellows,and bucket bottom. These parts are field together with.stainless Figure 5 steel retaining bands. DO NOT loosen the stainless steel retaining bands securinq.the bellows to the containment bucket top 17. Install the spill.bucket covers. ring or the containment bucket bottom.Loosening the retaining bands voids any and all warranties.on 18. (Optimal):Instal the product idenGfic4ft disc this product: on the spill bucket lover and multi-port cover in the I.D.disc recess. Warning*: 19.Cover the multi-port perimeter ring and cover ff the cover is removed,for any reason follow with plastic to prevent concrete from settling in the Service and Maintenancb instruction as the drainage areas. noted Always inspect and replace damaged o- 20. It is required that the perimeter ring and skirt rings and install new o-rings. Never reuse assembly,and the mufti-port cover be set as an damaged o-rings as it may resu/f in an improper assembled unit,with the bolts engaged. Failure seal to engage the bolts may result in the distortion of I