Laserfiche WebLink
At 125 mils, 13 square feet per gallon <br /> Drying Time To touch: 2 to 4 hours at 77°F <br /> To handle:4 to 6 hours at 77°F <br /> Curing 10-12 hours at 77°F and/or until a minimum Barcol Hardness <br /> reading of 70 or minimum Shore D Hardness reading of 75-80 is <br /> obtained. Cure time may be accelerated by post curing with <br /> heated air using an approved indirect fired heater with a <br /> minimum rating of 300,000 BTUs per hour. <br /> 2.5.2 EnvirolineTM 125U-9300. <br /> Material 100%solids,elastomeric,epoxy based caulking material for joints <br /> or where there is slight movement. <br /> Recommended Thickness 1/4- 1/2 inch. <br /> Viscosity Thixotropic <br /> Pot Life 30 minutes at 75°F <br /> Color White <br /> Coverage When ordering product, make allowances for any loss due to <br /> surface irregularities, etc. (approx. 15-20%) <br /> At 1/4 x 1/4 inch joint, 275 lineal feet per gallon <br /> Drying Time To touch: 2 to 3 hours at 77°F <br /> To handle:5 to 6 hours at 77°F <br /> Curing 72 hours at 77°F and/or until a minimum Shore D reading of 50 is <br /> obtained. <br /> Equipment Requirements trowel <br /> 2.5.3 EnvirolineTM 1250 Chemical Resistance Properties - Films cured for seven (7) days at 77°F are <br /> unaffected by the following products after one (1) year immersion at 77°F. <br /> Product Results <br /> ASTM Reference Fuels A and C OK <br /> Benzene OK <br /> Diesel Fuel OK <br /> Ethanol/Gasoline Blends (100%EtOH) OK* <br /> Gasohol (30%EtOH or McOH) OK <br /> Gasoline, Aviation OK <br /> Gasoline, Leaded OK <br /> Gasoline, Unleaded OK <br /> Gasoline,with co-solvents OK <br /> Jet Fuel (Jet A, JP4 and JP5) OK <br /> Kerosene OK <br /> Methanol/Gasoline Blends (100%McOH) OK* <br /> Mineral Spirits OK <br /> Oil, Fuel OK <br /> 2/99 <br /> Page I I of 30 <br />