COMPLIANCE INFO_2005-2009 - Laserfiche WebLink

Home Browse Search

- 3 - 6. -6, The processor shall activate when the pressure Of the underground b e tank is less than 0,equal to 0A inches Wc (:50.4 inches WC) as determinedby Exhit 9. 7. The TLS-350 alarm shall activate when the emission factor is at or greater an 0.64 Pounds/1000 gallons dispensed over a 24 hour period. A visual and and blethalarm shall activate when this emission factor is exceeded for the first and second 24m periods, 8- The pressure reading from the TLS console shall be within ±0.2 inches measured ullage UST Pressure as determined by section 8 of Exhibit 8.WC of the 9. The TLS-350 audible alarm shall be installed at a location that is Most likely to be g ort Occupied by the station attendant during normal station operation (i.e., cash reiste r). 10. The TLS console controlling the membrane shall have an RS232 Pwhich shall be installed in a location that allows the R8232 Port to be easily accessible, and if appli Per district requirements, for use at anytime. A vacant R3232 serial Port shall alwaycable s be available to electronically download reports. Yeeder-Root Va orP The carbon type shall be BAX 61500 manufactured by MeadWestvaco. 2. Unless there is maintenance or testing being conducted on theprocessor, the vapor Polisher shall be on and in the automatic Vapor Processor mode and the inlet ball valve shall be locked in the open Position shown in Figure 2B-3 for normal Polisher operation. The handle of the ball valve shall not be removed. 3. The Pressure reading from the TLS console shall be within ±0.2 inches WC of the measured ullage UST pressure as determined by section 8 of Exhibit 8. 4. The Vapor Pressure Sensor shall be between +0.2 and—0.2 inches WC when tested in accordance with section 9 of Exhibit 8. 5. The Vapor Polisher leak rate difference between starting and ending Pressures shall be less than 0.5 inches WC loss when tested in accordance with Exhibit 11. The ending Pressure must be greater than 7.0 inches WC. Pressure drop across the Vapor Polisher at 18.0 standard cubic feet per hour flow shall be between 1.69 inches WC and 2.25 Inches WC when tested in accordance with Exhibit 11. Differences in temperature readings shall not exceed 10 OF when tested in accordance with Exhibit 11. The atmospheric pressure sensor reading shall be within 10% of the atmospheric pressure obtained from a local independent source when tested in accordance with Exhibit 11, 6. The hydrocarbon concentration from the vapor Polisher outlet shan not ex % volume iso-butane (9,000 PPMV or 50% of the lower explosive level (LEL))ceed when t0.9eby sted in accordance with Exhibit 12. VST Phase 11 EVR System, Exhibit 2 -VR-203-E