COMPLIANCE INFO_2005-2009 - Laserfiche WebLink

Home Browse Search

-5- 3. The dispenser shall be connected to the riser with either flexible or rigid material that is listed for use with gasoline. The dispenser-to-riser connection Shall be installed so that any liquid in the lines will drain toward connector, including the storage tank. The internal diameter Of the g all fittings, shall not be less than one inch (I"). Note: The dispenser-to-riser connection is defined as the Piping connection between the also be Part of the riser connection, dispenser Piping and the inlet of the dispenser riser. A vapor shear varvemay 4• There is no length restriction for the vapor return Piping of the system as as system complies with the maximum Pressure drop requirement, item I oflong the Vapthe or Collection section. 5. No Product shall be dispensed from any fueling point at a GDF installed with the VST Phase 11 EVIR System if there is a vapor line atmosphere. that is disconnected and open to the 6, No liquid condensate traps are allowed with this system, Disnensers 1. For new installations and existing installations replacing dispensers or dispenser vapor Piping, the minimum nominal internal diameter of dispenser vapor Piping shall be one inch (v ID), For existing installations, installed dispenser vapor Piping May remain in t, item use as long as the system complies with the maximum pressure drop requiremen I Of the Vapor Collection section, 2. Dispenser vapor piping shall be installed so that an liquid in the lines will drain toward the dispenser riser. y The Phase I system shall be an ARB-certified -system that demonstrates compliance with the static pressure decay test criteria contained in TP-201.3 and Exhibit 4. h—fia 1 n tft–n an ce_Records 1. Each GDF operator owner shall keep records of alarms and maintenance performed at the facility. Such records shall be maintained on site in accordance with district requirements or Policies. The records shall include alarm date and time, nature of the alarm, troubleshooting, maintenance or repair performed to validate and/or correct alarms, component, or system ted Technician Identification Number of individual conducting conducted, name and Certified failures, date when maintenance or repair was maintenance or test, affiliation, and telephone number. Additional information may be required in accordance with local district requirements maintenance and alarm . An exapVle of a GDF record is shown in Figure 213-4, 2. Maintenance shall be conducted in accordance with the Scheduled Maintenance section of the ARB approved Installation, Operation, and Maintenance Manual. VST Phase 11 EVR System, Exhibit 2-VR-203-E