COMPLIANCE INFO_2005-2009 - Laserfiche WebLink

Home Browse Search

The following is deemed a defect for the affected fueling Point(s) ors ystem, Fueling Points 1. The fueling Point shall be removed from service when more than 30% of a seal is Missing (e.g., a triangular or similar shape in which greater then 2.5 inchnozzle face es of the faceplate circumference is Missing (accumulated)), Z The fueling Point shall be removed from service when more than 0.375 square inches of a nozzle vapor collection sleeve is Missing (e.g., a rectangular shape Of greater than nine/sixteenth (9/16) inches or more on each side, a circular shape of eleven/sixteenth {11/16) inches or more in diameter, or a the side. triangular shape of seven/eighth (7/8) inches on 3. The fueling point shall be removed from service when the total slit legth convolutions exceeds 18 inches as determined by direct measurements, in the 4. The fueling Point shall be removed from service when a hose is found than 175 ml of gasoline in the vapor side as determined by sections 6.1 to have greaterof Exhibit 5. Note: Prior to draining gasoline from the vapor side of the VST hose, use VST tool P/N VST-STP-100 and Plug the fuel spout. Do not activate dispenser when draining gasoline from the vapor side Of the VST hos,9. 5. The fueling Point shall be removed from service when VST system pressure dr exceeding the following conditions as determined by Methodology I of TP-201,4 s 5.00 inches WC at a now rate of 60 CFH of Nitrogen; and 6. &00 inches WC at a flow rate Of 80 CFH of Nitrogen. The fueling Point shall be removed from service when the dispensing rate is greater than ten 0 0) gallons per minute (gPM) or less than five (5) as determined applicable Provisions of section 6 or 7 of Exhibit 5 or by dirgpm ect observation by forthe 30 seconds minimum at the maximum hand held Position. 7. The fueling Point shall be removed from service when any hose has a visible opening s determined by direct observation, e a 8. The fueling Point shall be removed from service when the insertion interlock mechanism allows dispensing when the bellow is uncompressed as determined by direct observation 9. or GDF-09 (see Vapor Recovery Defects List). The fueling Point shall be removed from service when the nozzle automatic liquid shut- off mechanisms malfunction in any manner as determined by EPO Na. 26-F (See Vapor Recovery Defects List) or direct observation. 10. The fueling Point shall be removed from service when any nozzle has a defective vapor valve as determined by Exhibit 10 or when the vapor valve has a leak rate that exceeds VST Phase 11 EVR System, Exhibit 2-VR-203-E