Laserfiche WebLink
PRYCO, INC. 0 <br />0 <br />ELECTRICAL (Continued) <br />Option <br />..- <br />217 <br />FLOAT SWITCH (Standard) — This switch controls the start and stop of the <br />pump motor. There are two sensors: <br />• an ON sensor normally set at the 86% level, and <br />• an OFF sensor that is normally set at the 100% level. <br />This option includes a bypassing "press -to -test' momentary contact switch to <br />manually test the pump motor, and an amber pump -running light. The contactor <br />has two N.O. and two N.C. secondary terminals that is rated at 15 amps. <br />218 <br />DOUBLE POLE/DOUBLE THROW (DPDT) FLOAT SWITCH (Replaces Stan- <br />dard Float Switch #217) — This switch functions the same as our Standard Float <br />Switch (option 217) with the exception — this switch has an additional set of two <br />N.O and two N.C. secondary terminals rated at 15 amps. <br />219 <br />HEATER & THERMOSTAT — An assembly used to heat the fuel oil inside a tank <br />to maintain a specified temperature. While the thermostat controls the on/off of <br />the actual heater to achieve desired fuel temperature, a float switch and relay <br />monitors fuel level If the fuel drops below a pre-set level of 1" above the heater, <br />the heater is shut off regardless of the temperature. This is to protect the heater <br />from "burn -out'. <br />5 to 25 Gallons <br />219A <br />PY5 - PY25 — 300w,120vac <br />Above 25 Gallons <br />2198 <br />PY50-PY100 — 1000w,120vac <br />219C <br />PY150 - PY300 — 1500w, 120vac <br />219D <br />PY400 - PY500 — 2000w, 120vac <br />219E <br />PY600 - PY800 — 4000w, 240vac <br />219F <br />PY900 - PY1000-8000w, 240vac' <br />220 <br />MULTIPLEX REMOTE PUMP/MOTOR CONTROLLER — An automatic transfer <br />switching device used to control alternating remote pumps/motors pumping fuel <br />from main storage tank to any number day tanks. <br />221 <br />EXPLOSION PROOF LOW LEVEL SWITCH — An explosion -proof sensor that <br />activates remote outgoing signal when the fuel falls to a pre -determined level. <br />Includes dry terminal (30 -watt) contacts. Terminals located in explosion -proof <br />box. <br />222 <br />EXPLOSION PROOF HIGH LEVEL SWITCH — An explosion -proof sensor that <br />activates remote outgoing signal when the fuel rises to a pre -determined level. <br />Includes dry terminal (30 -watt) contacts. Terminals located in explosion -proof <br />box. <br />Page 14 P.O. Box 108, Mechanicsburg, IL 62545 (Phone -217-364/4467 Fax -217-364/4494) <br />The content of this catalog is subject to change without notification. <br />