Laserfiche WebLink
Following listings are the possible problems, causes and recommended remedies: <br />a. Power switch not turned on, make sure the power switch is turned to V <br />ON position. <br />b. AC power is connected improperly. Refer to section IIi.8. POWER INP, <br />WIRING, the 115 VAC line, neutral and ground must be wired to the correct t <br />urinals marked. <br />C. Fuse is blown, check the fuse continuity and replace if needed. Replacem, <br />fuse must be 2 amp 115 VAC or equivalent. <br />VAPOR2. <br />Possible causes and remedies: <br />Vapor present - monitoringwell.Remove Gsensor. the • <br />nito- <br />well, if the alarm stops, then it Indicates the presence of a vapor. <br />... - pointtoo sensitive. 7vaporalarm. -. when <br />removed. The alarm <br />is from the well,adjustepoint trimpotr.. i <br />cw <br />until the alarm stops. (See section I V.2.2. VA .i- ALARM ADJUSTMENTS <br />c. Vapor sensor failure. It the vapor sensor continues even after the sens, <br />removed from the monitoring well, and even after the sensor set point trimpo' <br />been turned counterclockwise all the way, disconnect the white sensor <br />from the safety barrier ZSB-2 terminal no.6, if the alarm stops, this indicate <br />presents of a short circuit in the sensor. <br />W <br />