Laserfiche WebLink
• 4 r <br /> 1 1 1 1 1 1 1 <br /> f <br /> c� <br /> STEP 7 Apply a bead of Blue Bond 801 around the housing threads - e5 <br /> and thread the repair boot onto the housing. <br /> t <br /> 1 t� <br /> • <br /> fi <br /> STEP 8 Index the repair boot with the fill tube at the 12:00 position. <br /> STEP 9 Install the split insert around the pipe and apply a liberal 'l} <br /> bead of Blue Seal Glue along the seam and lightly hold or <br /> clamp until cured. <br /> x <br /> t <br /> STEP 10 Install the insert into the repair boot. y. <br /> l <br /> STEP 11 Install the rear clamp and tighten to 65 inch lbs. (Be careful <br /> not to do this until the Blue Bond 801 is cured.) Install the <br /> outer clamp loosely so that air can escape between the insert <br /> and the boot while the boot is being filled with Bostik sealant. ' <br /> Fill the entire boot cavity with Bostik ROOFS sealant.As the (! r <br /> boot fills it will begin to pressurize and push the insert ?a <br /> outward. a <br /> i <br /> i <br /> AA <br /> eJ' <br /> STEP 12 Tighten the outer clamp to 65 inch lbs. Clean up any excess 1 <br /> sealant and allow 24-48 hours for Bostik i 100FS sealant to <br /> fully cure. <br /> _ {1 <br />