Laserfiche WebLink
Executive Order VR -101-A, Exhibit 3, Page 8 <br />Figure 3F <br />Phil-Tite 85001 -NV Vapor Recovery Spill Container and Inner Assembly <br />Component Warranty Tag. Placed on outside <br />of spill container, near top, just below upper lip. <br />INSTALLATION INSTRUCTIONS: <br />Cut and fit tank riser to terminate approximately 20" below finish grade. Use coupler and <br />factory nipple to finish riser height to terminate 13-3/4" below finish grade. Next, measure <br />and cut drop tube on a bias (minimum 2" from tank bottom - maximum 6" from bottom) and <br />install tank bottom protector if needed. Install drop tube with proper seals. Install Product <br />bucket and torque to approximately 50 ft. lbs. (using Phil-Tite Enterprises' tool kit - part <br />#T-7043). <br />Next install swivel adaptor using Phil-Tite Enterprises' tool kit - part #T-7043 (available <br />in our catalog) and torque to approximately 30 ft. lbs. Tighten setscrews to secure swivel. <br />The use of any unapproved tools, or over tightening bucket or swivel, will void any and <br />all applied warranties. <br />MAINTENANCE INSTRUCTIONS: <br />Routinely clean and inspect bucket quarterly. <br />ITEM <br />PART No <br />DESCRIPTION REQ'D <br />1 <br />85019 <br />FLANGE NUT 1 <br />2 <br />85018 <br />COMPRESSION RING 1 <br />3 <br />85065 <br />INNER COLLECTOR BUCKET 1 <br />4 <br />85036-N <br />BUCKET 0 -RING 1 <br />5 <br />85035 <br />RISER TUBE O-RING (OUTER) 1 <br />6 <br />85039 <br />RISER TUBE FLAT SEAL (INNER) 1 <br />7 <br />85020-V <br />RISER TUBE (VAPOR REC) 1 <br />