Laserfiche WebLink
0 • <br />Executive Order VR -101-A, Exhibit 3, Page 12 <br />Figure 3J <br />Phil-Tite SWV-101B Vapor Recovery Swivel Adaptor <br />INSTALLATION INSTRUCTIONS: <br />Cut and fit tank riser to terminate approximately 20" below finish grade. Use coupler and <br />factory nipple to finish riser height to terminate 13-3/4" below finish grade. Next, measure <br />and cut drop tube on a bias (minimum 2" from tank bottom - maximum 6" from bottom) and <br />install tank bottom protector if needed. Install drop tube with proper seals. Install Product <br />bucket and torque to approximately 50 ft. lbs. (using Phil -Tice Enterprises' tool kit - part <br />#rT-7043). <br />Next install swivel adaptor using Phil-Tite Enterprises' tool kit - part #T-7043 (available <br />in our catalog) and torque to approximately 30 ft. lbs. Tighten setscrews to secure swivel. <br />The use of any unapproved tools, or over tightening bucket or swivel, will void any and <br />all applied warranties. <br />0 <br />` /4 O 1 r <br />4SS� 3 4 \ <br />Mei Y \ 5 <br />ITEM DESCRIPTION <br />1 <br />SWIVEL TOP (VAPOR REC.) <br />2 <br />TEFLON TENSION RING <br />3 <br />URETHANE WIPER SEAL <br />4 <br />BALL BEARINGS (72 EACH RACE) <br />5 <br />VITON 0 -RING <br />6 <br />SWIVEL BASE (VAPOR REC.) <br />7 <br />BUNA GASKET <br />8 <br />SNAP RING (INT.) <br />9 <br />SPIDER <br />10 <br />SPRING <br />11 <br />SAFETY SNAP RING (EXT.) <br />12 <br />SNAP RING (INT.) <br />13 <br />SHAFT <br />14 <br />FLATWASHER <br />15 <br />SNAP RING (EXT.) <br />16 <br />POPPIT <br />17 <br />VITON 0 -RING <br />REQ'D <br />NOTE: <br />THIS ITEM IS NOT FIELD REBUILDABLE <br />Phil-Tite Enterprises, Inc. <br />3732 Electro Way <br />Redding, CA 96002 <br />Phone -530-223-7400 <br />Fax -530-223-7418 <br />WARRANTY CARD <br />This product is warranted by Phil-Tite Enterprises, Inc. <br />against defective material and workmanship for 1 (one) <br />year from installation date. We will repair/replace, as we <br />deem necessary, product that has been verified defective <br />by a representative of our company. Any damage caused <br />by either freight or wrongful installation are not covered <br />under this warranty. This warranty does not cover normal <br />wear, or force majeure - caused by fire, flood, earthquake, <br />explosion, war, or acts of God. Seals and 0 -rings are not <br />a warranty item. Warranty is null and void if a) item is <br />disassembled, b) item is installed improperly, or c) <br />warranty label has been tampered with or is removed <br />from product. <br />Expiration Date: <br />Serial Number: <br />Model Number: Mfg. Number: <br />This card must be retumed to manufacturer for warranty to be honored <br />