Laserfiche WebLink
0 <br />Executive Order VR -101-A, Exhibit 3, Page 11 <br />Figure 31 <br />0 <br />Phil-Tite SWF-100-B Product Swivel Adaptor <br />INSTALLATION INSTRUCTIONS: <br />Cut and fit tank riser to terminate approximately 20" below finish grade. Use coupler and <br />factory nipple to finish riser height to terminate 13-3/4" below finish grade. Next, measure <br />and cut drop tube on a bias (minimum 2" from tank bottom - maximum 6" from bottom) and <br />install tank bottom protector if needed. Install drop tube with proper seals. Install Product <br />bucket and torque to approximately 50 ft. lbs. (using Phil-Tite Enterprises' tool kit - part <br />#T-7043). <br />Next install swivel adaptor using Phil-Ttte Enterprises' tool kit - part #T-7043 (available <br />in our catalog) and torque to approximately 30 fL lbs. Tighten setscrews to secure swivel. <br />The use of any unapproved tools, or over tightening bucket or swivel, will void any and <br />all applied warranties. <br />P <br />ITEM DESCRIPTION R.EQ'D <br />SWIVEL TOP (FILL) <br />TEFLON TENSION RING <br />URETHANE WIPER SEAL <br />BALL BEARINGS (72 EACH RACE) <br />VITON 0—RING <br />SWIVEL BASE (FILL) <br />BUNA GASKET <br />Phil-Tite Enterprises, Inc. <br />3732 Electro Way <br />Redding, CA 96002 <br />Phone -530-223-7400 <br />Fax - 530-223-7418 <br />WARRANTY CARD <br />This product is warranted by Phil-Tite Enterprises, Inc. <br />against defective material and workmanship for 1 (one) <br />year from installation date. We will repair/replace, as we <br />deem necessary, product that has been verified defective <br />by a representative of our company. Any damage caused <br />by either freight or wrongful installation are not covered <br />under this warranty. This warranty does not cover <br />normal wear, or force majeure - caused by fire, flood, <br />earthquake, explosion, war, or acts of God. Seals and O - <br />rings are not a warranty item. Warranty is null and void <br />if a) item is disassembled, b) item is installed improperly, <br />or c) warranty label has been tampered with or is <br />removed from product. <br />Expiration Date: <br />Serial Number. <br />Model Number: Mfg. Number: <br />This card must be retum'ed to manufacturer for warranty to be honored <br />