Laserfiche WebLink
*4 <br /> CPT Controller Manual, is REDJA <br /> CKET <br /> Setting the DIP Switches for Stand-alone or Tandem Operation <br /> Step 1: Disconnect the ribbon cable. <br /> DIP SWITCHES <br /> u <br /> RIBBON <br /> CABLE <br /> CONNECTOR <br /> RS-232 <br /> PORT <br /> s <br /> s <br /> FIGURE 3.2 DUAL IN-LINE PACKAGE(DIP)Sw cHEs <br /> Step 2: Slide the three-board assembly out of the controller. <br /> Step 3: Set the DIP switches for the required mode of operation <br /> (stand-alone or tandem) using the chart below. <br /> Stand-alone Tandem Pole Positions <br /> DIP Switch Pole Position DIP Switch _Master Auxiliary <br /> 1 Closed 1 Closed Closed <br /> *2 Open *2 Open Open <br /> *3 Open *3 Open Open <br /> 4 Closed 4 Closed Closed <br /> *5 Open *5 Open Open <br /> 6 Open 6 Closed Open <br /> 7 Open 7 Closed Closed <br /> 8 Closed 8 Closed Oen <br /> *DIP switches 2, 3, and 5 are undefined and not applicable to operation. <br /> The default factory setting is Open. <br /> For an explanation of each DIP switch pole position, see "DIP <br /> Switch Settings" in chapter 5. <br /> ARE260-240 Rev.A ♦ 6/97 3-5 Chapter 3:Installation <br />