Laserfiche WebLink
CPT Controller ManualMPREDIJACKET <br /> �4 <br /> NO CONNECTION <br /> L1 <br /> n <br /> s L2 <br /> L3 <br /> FIGURE 3.3 ATTACHING THE INPUT CONNECTORS <br /> Step 2: Make the following wiring connections on the input power <br /> connector, as shown in figure 3.3: <br /> 0 L1 to L1 <br /> 0 L2 to L2 <br /> 0 L3 to L3 (if three-phase power is being used for the input <br /> power) <br /> \ Notice . The input power connector is the four-slot connector <br /> on the Capacitor board,which is closest to the top of <br /> the CPT Controller. <br /> Step 3: Attach an earth ground to the chassis ground lug located <br /> on the bottom of the controller, inside the enclosure. <br /> The installer must attach all safety earth ground wires. <br /> Failure to attach any ground lead may result in severe <br /> personal injury, death, or substantial property damage, <br /> if ignored. <br /> ARE260-240 Rev.A ♦ 6/97 3-7 Chapter 3: Installation <br />