Laserfiche WebLink
Safety Warnings <br /> This device is installed in equipment where potentially lethal voltages may <br /> exist.This device attaches to accessory components which operate in areas <br /> where flammable liquids and vapors may be present. <br /> Serious injury or death from shock,explosion,or fire may result if power is on <br /> during installation and the device is improperly installed. <br /> When installing this product: <br /> 1. Read and understand all instructions. <br /> 2. Turn off,tag,and lockout power to the console and submersible pumps <br /> while installing the PLLD system. <br /> 3. Use only Veeder-Root supplied service parts to avoid compromising <br /> safety. <br /> 4. Do not allow PLLD pump control wires to share conduit with wires from <br /> intrinsically safe devices such as probes and sensors. <br /> 5. Insure that any assembled conduit only enters the console through the <br /> properly designated knockouts. <br /> 6. Wiring must comply with all applicable requirements of the National <br /> Electrical Code;federal,state,and local codes; and any other safety <br /> codes. <br /> 7. To protect yourself and others from being struck by vehicles, block off <br /> your work area during installation or service. <br /> IMPORTANT! If there is a Stage 11 Vapor Recovery System installed that includes a device in the pressurized piping,see <br /> "PLLD Installation with Stage 11 Vapor Recovery Systems"on page 4-12 for installation guidelines. <br /> Transducer Installation - I <br /> This installation procedure is to be used with Red Jacket(Excluding Quantum w/SpikeCheck Valve&CPT,and <br /> Maxxum Big-Flo),Tokheim,or Bennett Pumps. <br /> INSTALLING THE SWIFTCHECK VALVE <br /> The SwiftCheck valve mounts directly into the mechanical line leak detector pump port. It eliminates the need to break <br /> product lines for installation and service. It also provides a means of precision testing the discharge O-ring and threaded <br /> discharge. <br /> Since the SwiftCheck valve replaces the existing mechanical device,it is suitable in applications where there is no sump. <br /> Follow the steps below to install a SwiftCheck valve in a Red Jacket,Tokheim,or Bennett pump. For Bennett pumps,be <br /> sure that an LLD tee fitting is installed before you install the SwiftCheck valve. <br /> 1. Do one of the following: <br /> a. If the submersible turbine pump is equipped with a mechanical LLD,remove the mechanical unit and any related <br /> tubing and fittings,or <br /> b. If the submersible turbine pump is not equipped with a mechanical LLD,remove the 2-inch mechanical LLD port <br /> plug. <br /> 4-1 <br />