COMPLIANCE INFO_2003-2005 - Laserfiche WebLink

Home Browse Search

t Safety Warnings Circuitry within the PLLD transducer and console barrier form an intrinsically safe,energy-limited system.This system makes the transducer intrinsically safe for use in a Class I,Group D hazardous location.The transducer wiring is intrinsically safe only when connected to Series Consoles. f � � This equipment uses lethal voltages and attaches to accessory components which operate in areas where flammable liquids and vapors may be present. lir Serious injury or death from shock,explosion,or fire may result if power is on �� during installation and the device is improperly installed. When installing this product: I, Read and understand all instructions. 2. Turn off,tag,and lockout power to the console,dispensers,and submersible pumps while installing the PLLD system. 3. Use only supplied service parts to avoid compromising safety. 4. Do not allow PLLD pump control wires to share conduit with wires from intrinsically safe devices such as probes and sensors. 5. Insure that any assembled conduit only enters the console through the properly designated knockouts. 6. Wiring must comply with all applicable requirements of the National Electrical Code;federal,state,and local codes; and any other safety codes. 7. To protect yourself and others from being struck by vehicles,block off your work area during installation or service. Refer to the following wiring diagrams as you connect the wiring: • PLLD system--Figure 3-2 on page 3-4 • Manifolded PLLD system--Figure 5-7 on page 5-7 or Figure 5-8 on page 5-8 • Red Jacket pumps--Figure 5-2 on page 5-4 through Figure 5-5 on page 5-5 • Non-Red Jacket pumps--Figure 5-6 on page 5-6 • Gilbarco Dispenser Isolation Box--Figure 5-9 on page 5-9 • Manifolded product lines-dual FE Petro IST-VFC Controllers--Figure 5-10 on page 5-10 • Manifolded product lines-dual Red Jacket IQ Controllers--Figure 5-11 on page 5-11 General Wiring Practices • Be sure all wires are color-coded or carefully marked to identify their source. • The PLLD Interface Module in the console comes with a connector in place.Do not remove the connector from the module or remove the module from its slot in the console during wiring.Terminal identifications appear only on the module bracket.Removing the connector from the module increases the risk of wiring errors. • Label all connectors,using the supplied self-adhesive labels,according to the slot in which the modules are installed. 5-1