Laserfiche WebLink
9 <br /> PLLD Site Prep and Installation Guide PLLD Interface Module Wiring Connections <br /> IMPORTANT! Once a connector has been wired on a module and the console has been programmed,the connector <br /> and module cannot be moved to another slot without reprogramming the system. <br /> • Record the location(i.e.,Line#1 (regular),Line#2(super),etc.)of each PLLD wired to a module on the circuit <br /> directory inside the console door. <br /> PLLD Interface Module Wiring Connections <br /> 1. Turn Off,tag, and lock out all AC power to the console and submersible pumps. <br /> 2. Connect the color-coded or marked wires from each PLLD transducer to the proper terminals on the PLLD Interface <br /> Module connector starting with position I [Figure 3-1 on page 3-31. Wire each position on the module(s)in order <br /> without skipping a position,e.g., 1,2,3,4,etc.,not 1,3,4. <br /> IMPORTANT! The console software will identify PLLD Controller Module positions 1-3 (one module)and 4-6(op- <br /> tional second module,highest in I.S.bay)with PLLD Interface Module positions 1-6.Therefore you must wire the <br /> PLLD System so that the STP connected to position Ion the PLLD Controller Module has the PLLD transducer in- <br /> stalled that is connected to the position 1 on the PLLD Interface Module.The same relationship holds for the remain- <br /> ing 5 positions. <br /> 3. Connect the bare wire(shield)to one of the ground screws in the console only. <br /> 4. Maintain correct circuit orientation between the color-coded or marked field wires and connector terminals during <br /> wiring. <br /> PLLD Transducer Field Wiring Connections <br /> 1. Turn Off,tag and lock out all AC power to the console and STP. <br /> 2. Using wire nuts,connect the white and black wires from the PLLD transducer to field wires in the junction box.Be <br /> sure to maintain correct circuit orientation between the color-coded or marked field wires and PLLD <br /> transducer wires during wiring.Cut off the transducer shielded ground wire(if present)flush with the cable <br /> jacket.Do the same for the cable shield. <br /> IMPORTANT! Connect the shielded cable to the shielded ground wire lug(supplied)in the intrinsically safe area of <br /> the console [Figure 3-2 on page 3-4];do not connect it to the transducer. <br /> 3. Seal wire nut connections using the epoxy sealant furnished with each PLLD. Use one packet for no more than two <br /> wire nut connections.Ensure the end of the cable jacket is covered by the epoxy.Refer to Figure 5-1 as you <br /> prepare epoxy and seal connections. <br /> t (�) Q <br /> CAUTION:Epoxy sealant is irritating to eyes,respiratory system,and skin. Can cause allergic skin reaction. Contains: <br /> epoxy resin and Cycloaliphatic epoxycarboxylate.Precautions: Wear suitable protective clothing,gloves,eye, and face <br /> protection.Use only in well ventilated areas.Wash thoroughly before eating,drinking,or smoking. <br /> 5-2 <br />