COMPLIANCE INFO_2003-2005 - Laserfiche WebLink

Home Browse Search

PLLD Site Prep and Installation Guide PLLD Controller Module Wiring �I��—�� . From probe, \, sensor,or J 7 transducer To console Make sure that the ends of cable \1 i sheathing are subs merged in sealant f Tie wrap ,---Wire nuts -uf> Instructions: NOTE: When temperature is below 50T (10°C), 4. Mix thoroughly to a uniform color by squeezing keep resin in a warm place prior to mixing(e.g., contents back and forth 25-30 times. in an inside pocket next to body). 5.Squeeze mixed,warm resin into one end of bag 1. Open epoxy sealant package,and remove resin and cutoff other end. pak. 6. Slowly insert wiring connections into sealing 2.Holding resin pak as shown in A,bend pak along pack until they fit snugly against the opposite long length. end as shown in C. 3.As shown in B,firmly squeeze the RED SIDE of 7.Twist open end of bag and use tie wrap to close the resin, forcing it through the center seal and it off and position the tie wrapped end up until into BLACK SIDE. the resin jells. probes„epxy2w.eps Figure 5-1. Epoxy Sealant Connections IMPORTANT! Do not put more than two wire nut connections in one epoxy sealant bag or the connections will not be properly sealed. Improper sealing of the connections will result in inaccurate system readings and possibly false alarms. PLLD Controller Module Wiring PLLD pump control wiring varies depending on the pump manufacturer's relay control box.Refer to the appropriate wiring diagram (circuit diagrams are for switched"hot”dispensers): • Red Jacket--Figure 5-2 on page 5-4 through Figure 5-5 on page 5-5 • Non-Red Jacket--Figure 5-6 on page 5-6 • Manifolded--Figure 5-7 on page 5-7 or Figure 5-8 on page 5-8 • Gilbarco Dispenser Isolation Box--Figure 5-9 on page 5-9 IMPORTANT! Dispensers and console must be wired to the same leg of incoming power at the main electrical panel; otherwise damage may result to both. The console must be able to detect when dispensers are switched On or Off so it only initiates line leak tests when the dispenser is switched Off. The console must also be able to start the submersible pump to perform a line leak test,and shut off the pump if a leak is detected. IMPORTANT! The console,when wired correctly,will control the pump independent of the dispenser control circuits.It is imperative that when the Emergency Stop switch is wired and tested the console's pump control circuitry CANNOT switch On the pump.To ensure that the pumps are unable to be activated in an emergency situation,it is best to have the Emergency Stop switch interrupt pump power at the circuit breaker panel via shunt breakers. Note: (OPTIONAL)In order to prevent 3.0 gph tests from running when STP power is switched Off,an Interlock relay may be used on the PUMP IN signal(ref.Figure 5-3 and Figure 5-7). • 5-3