Laserfiche WebLink
D. results ofTestinglServicing E T Dispatch <br /> Software Version Installed: <br /> COMD[ete the foliowin checklist: . _.:. <br /> 2'Yes ® No* Is the audible alarm operational', <br /> a Yes ® No* Is the visual alarm operational? <br /> Yes No* Were all sensors visually inspected,functionally tested.and confu-med operational? <br /> Q'Yes Q No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> E3 Yes ® No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> Er N/A operational? <br /> Yes ® No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ® N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) @'Sump/Trench Sensors; O'Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ®'(Yes; ®No. <br /> Q Yes M� No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> ® N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> . fillpoint(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger? % <br /> 5Yes* Q No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> Q Yes* No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> Product; ®Water. If yes,describe causes in Section E,below. <br /> Yes ® No* Was monitorings stem set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> Lir Yes Cl No* Is all monitoring a ui mentoperational 2er manufacturer's specifications? <br /> *In Section,E below,describe bow and when these deficiencies were or will be corrected. <br /> E. Comments: , "In I escd Z 1 r <br /> Page 2 of 3 <br />