COMPLIANCE INFO_2012-2018 - Laserfiche WebLink

Home Browse Search

6. PIPING SUMP TESTING Test Method Developed By: F Sump Manufacturer F Industry Standard F Professional Engineer F Other(Specify) Test Method Used: F Pressure F Vacuum F Hydrostatic F Other(Specify) Test Equipment Used: Incon TS ST^S Equipment Resolution: .0006 COmments — (include information on repairs made prior to testing, and recommendedfollow-up for failed tests) Reinstall sensors at lowest point but not tested. (1) Ifthe entire depth of the sump is not tested, specify how much was tested. Ifthe answer to any of the questions indicated with an asterisk (*) is "NO" or "NA", the entire sump must be tested. (See SWRCB LG -160) Sump Sump Sump Sump 111MEMM Piping/FillUG010U001 Vent Trans. UG010U001 Piping Trns. UG0100001 Sump Diameter: 48" 26"x18" 28"x28" Sump Depth: 60" 36" 36" Sump Material: Fiberglass Fiberglass Fiberglass Height from Tank Top to Top of 24" 14" 14" Highest Piping Penetration: Height from Tank Top to Lowest 18" 27„ 27„ Electrical Penetration: Condition of sump prior to Good Good Good testing : Portion of Sump Tested (1) 2" above piping 2" above piping 2" above piping Does turbine shutdown when sump sensor detects liquid (both F Yes r No IV NA - r� � r P Yes I No F0 NA 1 Yes i No 1- NA r � I I Yes No r NA product and water)?* Turbine shutdown response time N/A N/A N/A Is system programmed for fail- Yes r No !_ NA I Yes ! NolT NA Yes No 0_ NA F Yes F No F NA safe shutdown?* Was fail-safe verified to be F Yes F NoF NA F Yes No NA F Yes 1 No NA F Yes F No F NA operational?* Wait time between applying pressure/vacuum/water and 15 min 15 min 15 min starting test: Test Start Time. 9:44 am 10:00 am 9:44 am 10:00 am 9:44 am 10:00 am Initial Reading (Rl): 5.8281 5.8279 2.9989 2.9986 6.2582 6.2593 Test End Time: 9:59 am 10:15 am 9:59 am 10:15 am 9:59 am 10:15 am Final Reading (RF): 5.8281 5.8278 2.9988 2.9985 6.2586 6.2593 Test Duration: 15 min 115 min 15 min 115 min 15 min 15 min Change in Reading (RF Rl): 0 .0001 .0001 .0001 .0004 0 Pass/FaiI Threshold or Criteria: .002 .002 .002 1.002 .002 1.002 Test Result: F Pass F Fail Pass F Fail Pass Fail F Pass Fail Was sensor removed for testing? 1� Y. No F NA � �' Yes F No F NA FY. F No NA Yes Nor— NA Was sensor properly replaced and F Yes No NA Yes No NA Yes No NA F Yes No NA Venfied functional after testing? COmments — (include information on repairs made prior to testing, and recommendedfollow-up for failed tests) Reinstall sensors at lowest point but not tested. (1) Ifthe entire depth of the sump is not tested, specify how much was tested. Ifthe answer to any of the questions indicated with an asterisk (*) is "NO" or "NA", the entire sump must be tested. (See SWRCB LG -160)