COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

Regulatory Cross Reference Version :27.10.4 CALIFORNIA •DOF • DIVISIONTITLE 14 :D • SECTION BRIEF DESCRIPTION LOCATION IN PLAN 817.04(k) Inland Facility Description and Reasonable Worst Case Spill App. B Volume 817.04(k)(1) Each plan shall describe the Inland Facility's design and operations ----- with specific attention to those locations from which an oil spill could occur and impact Waters of the State. 817.04(k)(1)(A) A general diagram of the Inland Facility; Fig. 1.2 817.04(k)(1)(B) Well locations by field; N/A 817.04(k)(1)(C) Relevant piping and tank diagrams including the location of lines; oil App. I storage capacity of each structure covered under the plan and its age, design, construction and general condition; the range of oil products normally stored in each structure 817.04(k)(1)(D) A description of the oil types, physical properties and health and Fig. 1.1 safety hazards. A Safety Data Sheet (SDS)or equivalent will meet some of the requirements and can be maintained separately at the Inland Facility, providing the plan identifies its location; 817.04(k)(1)(E) Maximum storage or handling capacity and current normal daily Fig. 1.1 throughput of oil handled; 817.04(k)(1)(F) A description of the normal procedures for transferring oil, and the App. I amount, frequency and duration of the oil transfers; 817.04(k)(1)(G) The Inland Facility's normal hours of operation; and Fig. 1.1 817.04(k)(1)(H) Vicinity maps showing any vehicular access to the Inland Facility, App. I nearby residential, commercial or other populous areas and access to private land necessary to respond to a spill. 817.04(k)(2) For a Railroad,... N/A 817.04(k)(3) The Reasonable Worst Case Spill (RWCS)volume for an Inland ----- Facility, calculated in barrels, is as follows: 817.04(k)(3)(A) Production Facilities: Ten percent (10%)of the daily average of the N/A largest producing well. 817.04(k)(3)(B) Distribution Pipelines: The pipeline's maximum release time in App. B hours (i.e., the time between pipeline rupture and discovery), plus the maximum shut-down response time in hours (based on historic discharge data or in the absence of such historic data, the operator's best estimate), multiplied by the maximum flow rate expressed in barrels per hour(based on the maximum daily capacity of the pipeline), plus the largest line drainage volume after shutdown of the line section(s) in the response zone, expressed in barrels. Shell Supply and Distribution Cross Ref-28 Stockton Terminal FRP ©2019 Witt O' Brien's Revision Date:October, 2019