COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

50.Without ever placing hands inside the machine bag 51. Place needle loop over rubber grommet and slide down onto armature bar 52. Move rubber bands so they lay over the needle bar to hold it in place 53. Adjust needle and tube as necessary 54. Tighten front vice to hold tube in place 55. Attach clip cord 56. Tattoo BREAKDOWN: 1. Don two gloves and mentally designate one as clean and one as dirty 2. With clean glove, lift bottles, one at a time, remove barrier with dirty glove and place on storage shelf 3. Using dirty glove, unhook clip cord contact points by only touching the outside of the machine bag 4. Holding clip cord through cover with dirty hand, use clean hand to hold contact points between thumb and first finger, then with dirty hand, pull the plastic down away from them 5. Unplug clip cord from power supply with clean hand 6. With dirty hand slide barrier over clip cord 7. With clean hand;place clip cord on uncovered bench or chair 8. With dirty hand, place clip cord barrier on mayo tray 9. Pick up machine through barrier with needle facing down and away from any part of the body, remove rubber bands and rubber grommet from machine 10. With needle facing down and away from any part of the body, loosen the vice through the barrier 11. Carefully pull tube and needle from vice together in one piece 12. Immediately remove needle from tube, leaving tube on mayo tray, place needle into sharps container 13. Holding onto the contact screw with one hand, use the other hand to pull the barrier back over the machine to expose it 14. Without touching the outside of the bag to anything, place the machine on the same clean, uncovered surface as the clip cord 15. If using steel tubes, use inside portion of machine bag to open tube container and place tube inside then replace lid 16. If using disposable tubes, leave tubes on mayo tray 17. Remove barrier from all covered areas except mayo tray and place on mayo tray 18. Place one or two paper towel in each rinse cup, as needed then align all contents on mayo tray to wrap all together in a compact manner 19. Starting at one end of mayo tray, wrap all contents together by using the bottom piece of cellophane as the outermost cover with all other contents secured inside. Wrap from one end to the other paying close attention to any liquid ensuring it soaks into the clean field or paper towels 20. With used materials wrapped into a nice tight bundle held in one hand, use other hand to transfer glove from covering the hand to covering the bundle 21. Now holding bundle in opposite hand with opening in palm, again, transfer glove from