Laserfiche WebLink
all other completion tools ready at the well waiting for the driller to finish the well. It is the <br /> responsibility of the completion man to keep the waste cleaned up around the drill rig as soon as <br /> a load is available. <br /> The completion man needs to know to the exact foot of where each section of material is to stop <br /> (gravel, bentonite, and soil). While installing the materials into the well the completion man <br /> should constantly measure the materials he is putting in. <br /> When the well is complete the area around the well should not have ANY waste lying on the <br /> ground. The completion man and the helper can police the area by picking up all the smaller <br /> pieces and placing it in a trash bag. <br /> DE-MOBILIZATION <br /> Equipment(1-19-08G.C.)af100 BEFORE LOADING RIG CHECK THE FOLLOWING <br /> 1. TRACKS ARE SUCKED IN <br /> 2. MAST IS DOWN SETTING IN CRADLE BEHIND ENGINE COMPARTMENT <br /> 3. SAFETY CHAINS ARE ATTATCHED TO BAR AND CLEVISES ON FOOT OF MACHINE <br /> 4. SAFETY CLAMP IS AROUND BAR AND AGIANST ROTARY <br /> 5. USE STICKS AND PEDALS TO MOVE RIG DO NOT ADJUST ANYTHING WITH SMALL <br /> LEVERS ON DASH <br /> 6. ONLY USE LEFT JOYSTICK TO ROTATE CAB IN THE SIDE TO SIDE MOTION <br /> 7. DO NOT TOUCH RIGHT JOY STICK OR MOVE LEFT JOYSTICK FRONT TO BACK <br /> 8. ANY PROBLEMS OR QUESTIONS CALL Johnny Waters 225-445-5572 <br /> 9. SECONDARY GREG COOPER CELL 225-445-5795 OFFICE 419-424-4940 <br /> Equipment should be taken to the staging area. The equipment should be cleaned inside and out. <br /> It is easier to see all the leaks and repairs needed when the equipment is clean. <br /> Meet with the client, discuss with them your final paperwork and take a site tour. <br /> ADDITIONAL CONCERNS for the DRILLER <br /> Drill Cable <br /> Always pay attention to the drill cable for damaged spots. If the cable begins to fray, then <br /> replace it. Tilting the mast to the right will keep the cable from rubbing against the guide rollers. <br /> When going down the well bore do not hit the bottom hard. Hitting the bottom hard will cause a <br /> new cable to turn inside out. The auxiliary cable does not get much use but it needs to be <br /> watched when lowering the mast. The cable will rest on top of the cable. REMEMBER <br /> ALWAYS CARRY A SPARE CABLE. <br />