Laserfiche WebLink
17. Procedures to mitigate hazards <br /> Identify procedures to mitigate all hazards listed in Item 16 by placing the task number <br /> next to the appropriate mitigating measure. Listing of standard procedures is not <br /> inclusive. A specific procedure must be entered to mitigate each hazard identified in <br /> Item 16. <br /> Activity <br /> List Number Mechanical Hazards <br /> Z 3 4- Do not stand near backhoe buckets and earth moving equipment. <br /> Z 3 Verify that all equipment is in good condition. <br /> Do not stand or walk under elevated loads or Iadders. <br /> ( Do not stand near unguarded excavation and trenches. <br /> / Do not enter excavation or trenches over 5 feet deep that are not <br /> properly guarded, shored or sloped. <br /> 1 2 3 Consult DHSO if other mechanical hazards exist. <br /> Electrical Hazards <br /> _ 2 3 Locate and mark buried utilities before drilling. <br /> Utilities located by- on <br /> Maintain at least 10 foot clearance from overhead power lines. <br /> / Contact utility company for minimum clearance from high voltage <br /> r Z power lines. <br /> If unavoidably close to buried or overhead power lines, have power <br /> �a turned off, with circuit breaker locked and tagged. <br /> 3 Properly ground all electrical equipment. - - - <br /> :,,� Avoid standing in water when operating electrical equipment_ <br /> If equipment must be connected by splicing wires, make sure-all.— <br /> connections <br /> ure all._connections are properly taped. <br /> Be familiar with specific operating instructions for each piece of <br /> equipment. <br /> AE014-cP 6 .. <br /> July 1, 1"S <br />