Laserfiche WebLink
cheeSe MelteR <br />8 P/N 1010983 Rev B 05/08 <br />electrical <br /> 1. Place the unit on a sturdy, level table or <br />other work surface. Turn the unit off before <br />proceeding. <br /> 2. Ensure that the line voltage corresponds to <br />the stated voltage on the unit’s specification <br />label and power cord warning tag (Figure 1). <br /> 3. Connect the unit to the power supply. <br />PluMbing <br />note: cheese Melter models are designed <br />to use cold tap water. the use of a reverse <br />osmosis system is strongly recommended to <br />reduce mineral deposit buildup and reduce <br />maintenance costs. <br />The RS-250 requires a direct water hookup. An <br />installation kit is packed inside the unit. <br />installation (continued) <br />figure 1. Warning labels <br />208 VAC <br />ONLY <br />220-240 <br />VAC ONLY <br />THIS APPLIANCE MUST BE <br />EARTHED (GROUNDED) <br />THIS APPLIANCE MUST BE <br />EARTHED (GROUNDED) <br />THIS APPLIANCE MUST BE <br />EARTHED (GROUNDED) <br />THIS APPLIANCE MUST BE <br />EARTHED (GROUNDED) <br />THIS UNIT IS DESIGNED TO <br />OPERATE ON 220-240 VOLTS <br />ONLY. APPLICATION WITH ANY <br />OTHER VOLTAGE SUPPLY <br />COMPLETELY VOIDS ALL <br />WARRANTY. PLEASE CHECK <br />YOUR LINE VOLTAGE BEFORE <br />INSERTING THIS PLUG INTO THE <br />RECEPTACLE. <br />THIS UNIT IS DESIGNED TO <br />OPERATE ON 208 VOLTS <br />ONLY. APPLICATION WITH ANY <br />OTHER VOLTAGE SUPPLY <br />COMPLETELY VOIDS ALL <br />WARRANTY. PLEASE CHECK <br />YOUR LINE VOLTAGE BEFORE <br />INSERTING THIS PLUG INTO THE <br />RECEPTACLE. <br />WARNINGWARNING <br />WARNINGWARNING <br />caution <br />this equipment is to be installed to comply with <br />the basic plumbing code of the building officials <br />and code administrators, inc. (boca) and the <br />food service sanitation Manual of the food and <br />Drug administration (fDa). <br />caution <br />Water pressure must not exceed 20 psi (1.4 <br />kg/cm2 or 138 kPa). Higher water pressure <br />may cause poor performance or flooding. to <br />reduce water pressure, install a Water Pressure <br />regulator, and set water pressure to 20 psi (1.4 <br />kg/cm2 or 138 kPa). to order a Water Pressure <br />regulator from your authorized service agency, <br />order roundup part no. 7000235. <br />equipment setup <br />general <br />When placing the unit into service, pay attention to <br />the following guidelines: <br /> • Make sure the unit is off and at room <br />temperature. <br /> • Do NOT block or cover the openings on the <br />bottom of unit. <br /> • Do NOT immerse cord or plug in water. <br /> • Keep cord away from heated surfaces. <br /> • Do NOT allow cord to hang over edge of <br />table or counter.