Laserfiche WebLink
MVP-DAX DM SettingInstructions Or�ystems <br /> »j1_d <br /> 1-800-348-9843 <br /> Orenco's Most Versatile Panel (MVP) line of control panels includes an easy-to-use <br /> programmable logic unit that incorporates many timing and logic functions.The panel will <br /> accommodate timed dose or on-demand systems.The panels' default mode of operation is <br /> timed dose. Some operational parameters may need to be changed for your particular <br /> application. <br /> The unit uses block names to identify the various parameters (please refer to the Liquid Crystal <br /> Display screen shown in Step#3).The parameters for both modes of operation <br /> (Timed/Demand)will always be present,but only those that apply to the selected mode will be <br /> used.The following block types have been used with your control panel: <br /> Block Factory Time Block Timed/ <br /> Names Description Default Range Type Demand <br /> HLA Dly High Level Alarm Delay 5 seconds MASS Timer Both <br /> Off Time Timer Off Time 60 minutes MM:SS Timer Timed <br /> On Time Timer On Time 40 seconds MM:SS Timer Timed <br /> OVR Off Override Timcr Oft'"Vinic 30 minutes MM:SS "Timer Timed <br /> OVR On Override Timcr On Time 40 seconds MM:SS Timcr Timed <br /> MinOvrTm Minimum Override Time 90 minutes MM:SS Timer Timed <br /> MinRunT Minimum Pump Run Time 30 seconds MM:SS Timer Demand <br /> Pm I Lead Pump I as Lead Pump OFF On/Off Sol'Ekey Both <br /> Pm 2Lead Pump 2 as Lead Ptunp OFF On/Off SofEkey Both <br /> TimeDose Timed Dose O eration I ON J On/Off I Softke Both <br /> All adjustable parameters DO NOT use the same type of blocks; check the block types above <br /> to determine which steps apply to your application. <br /> q Changing Adjustable Parameter Blocks: <br /> Step 1: Press w repeatedly until the display does not change.To begin <br /> the configuration process,press the"ESC" key. <br /> SU 00:00 / <br /> 2008-01-01 <br /> ei��� CSC IlK <br /> y, Step 2: Press w on the unit to select"Set Param."Then press the <br /> >a .SOK" key. <br /> Stop Warning: Do not select"Stop:'Doing so may erase the panel <br /> Set.Param <br /> Pro Name programming,which cannot be restored without the use of an EEPROM <br /> 5, OK card,which is not included with the panel.If this is selected by accident,a <br /> confirmation screen will come up.Select"No"and press the"OK"key <br /> immediately. <br /> EIN-CP-SET-2212 <br /> Rev 1.0 J 01/10/13 <br /> Page 1 of 3 <br />