Laserfiche WebLink
Changing Adjustable Parameter Timer Blocks: <br /> Timer blocks have three timebase units that can be used; s = seconds, <br /> m =minutes,h=hours.If an h appears after the timer setting then the <br /> time will be HH:MM (e.g.01:55h= 1 hour and 55 minutes). If an m <br /> appears after the timer setting then the time will be MM:SS (e.g. <br /> 05:00m=5 minutes and 0 seconds).If an s appears after the timer <br /> OffTime setting then the time will be SS.ss (e.g. 25:1.3s=25.13 seconds). <br /> T -03:55h <br /> To..00:45 <br /> Step 3: Press I or r to view the parameter values.In this example, <br /> "Off Time" is being viewed. <br /> Step 4:The first line indicates the set value for the parameter. In this <br /> example,the set time is I hour and 55 minutes,"T=01:55h" To <br /> Tff g8:55m change the set value for the parameter, press the"OK" key. <br /> To-00:45 <br /> The second line indicates, in real time,how much time has elapsed <br /> for the cycle that is currently in process.The current value of the <br /> parameter is 45 minutes,"Ta=00:45." <br /> Step 5:The cursor will appear in the set value.To select the digit to be <br /> changed,press 4 or ►. To change the value of a digit,press I or <br /> w. In this example,the set value has been changed from 1 hour <br /> T <br /> To Ms4sand 55 minutes to 58 minutes and 15 seconds. (The timebase can <br /> -. ..:.- <br /> be changed from hours=h to minutes =m or seconds = s by <br /> moving the cursor to the far right and pressing I or •). <br /> Step 6: When the desired time value has been entered,press the"OK" <br /> key.The new time value will now be in effect. <br /> Step 7: To exit parameter mode,press the"ESC"key twice. <br /> EIN-CP-SET-2212 <br /> Rev 1.0©01/10/13 <br /> Page 2 of 3 <br />