COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

• 13)On page G.7.1 a single point annula ensor is bein roposed(instead of the dual high and low sensor),please revise and res bmit. Also the same G.7.1 only one FE Petro leak detector is being listed, clarify whi h leak d ectors will be installed on 87/91 tanks, revise the parts list to reflect the correct yste inventory Response: Item Z29 on sheet G7.1 indicates al float hydrostatic sensor is proposed. Item Z14 for the single point hydrostatic sens has been removed. There are three (3) FE Petro leak detectors listed (items Y01 and Y 2/ heet G7.1). Both were previously listed as Y01, which has been corrected. Y01 is th senso for the unleaded gasoline pumps (typ 2) and Y02 is for the diesel pump. 14)Please point out the spill contai rs and the'r water-t' ht VPH shields on the parts list and their reference number on drawings,ple se pro ide drawing reference where water tight construction is detailed or provide a rev* ed rawing illustrating the water tight construction of all sumps. Response: Multi-ports have been revised to a P il- ite multi-port package, which includes the watertight sump shields, muti-port manw , spil buckets, swivel adapters and caps, riser adapters, riser adjustment brackets, and ove ill valv s. See revised equipment schedule for revisions to items F26, F27, and F28 (as w 11 as item L19, L24, L26, L27, L29, L57, and L68) 1 S)Confirm that the UDC foot print ill mat the dispensers foot print and all piping and filters will drain directly into resp ti v UDC without any retrofit modifications,please provide a reference to that effect o our plans Response: The Bravo B8000 Serie D is ordered to fit the project specific Gilbarco Encore dispensers. The note on eet G 0/detail 3 has been expanded, stating, "The UDC foot print will match the dispe ers foot int and all piping and filters will drain directly into res e ' without any etrofit modi ations." 16)Please provide a detailed vacuum zone map illustrating ends of each vacuum zone, any vacuum jumper hoses, sensor location for each vacuum zone, and vacuum zone volumes. Response: A detailed vacuum zone map has been added as sheet G6.2 with the requested ormation. 17)Identify piping cross-over distances on your plans Response: Distances between pipes are clearly shown in detail 3/sheet G1.0 (12"min. between VR and product pipes). These distances translate directly to the crossovers as well. 18)Identify overfill and striker plates on tank n drawings Response: A note has been added to the cross/\/sheet G3.0: "See details 1 & 2, sheets G4.0 and G4.1 for fill tubes, overfill valnk probes, and striker plates. 19)Idents the location of monitoring panel and emergency shut off on your drawings