COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

STEP 18 : LOWER TUBE ASSEMBLY FOR STANDARD VAPOR TIGHT MODELS, PROCEED If a vise is used , clamp on the valve body casting only to TO STEP 20 ON PAGE 14. avoid damage to the float and tubes . Thread the lower tube onto the valve body until the lower tube bottoms FOR TESTABLE MODELS, PROCEED TO PAGE 13 . out on valve body. Tube can be tightened by hand or with a strap wrench . If a strap wrench is used try to po- sition it on the threaded insert portion of the lower tube to prevent damaging the tube . /"INN Threaded insert \ Figure 18 NOTE : Before installing the valve in the tank, a pres- sure test can be performed on the valve to check for vapor tightness . Seal off both ends of the tube with inflatable plumber's plugs . Apply a maximum 10" W .C . ( 1 /3 PSI ) air pressure . If pressure does not hold and a leak can be located with soap solution, do not install the valve . Send the valve back to OPW for warranty evaluation . CAUTION : Do not over-pressurize . Excess pressure can damage the valve . STEP 19 : CUT LOWER TUBE Measuring from the underside of the inlet tube flange, ' mark the overall length of the drop tube a distance of n Im _ vED ( B) minus 6 " . Determine dimension ( B) from the meas - urements taken in Step 1 , Figure 1 (Top of the Face Seal N 0 V 0 I ' 2019 Adapter below the drain valve outlet in the spill con - tainer to the bottom of the tank) . Saw off the excess ENVIRONMENTAL HEALTH tube at a 45 -degree angle or per local codes or require- ments and file off any sharp burrs ( Refer to Figure 24) . DEPARTMENT Optional : Install the OPW Tank Bottom Protector on the lower tube ( Refer to Installation instructions sup - plied with the Tank Bottom Protector) . IMPORTANT: Remove all chips and shavings out of the cut end of the tube . DO NOT remove chips and shav- ings by dumping thru valve body. 12