WORK PLANS - Laserfiche WebLink

Home Browse Search

POBAL® SPEC TO INSTALL WE DO IT ALL LIGHTING AND ELECTRICAL Door section may be provided with a factory-installed LED light fixture on the interior of the section and a light switch with pilot light indicator flush-mounted within a chromed steel plate on the exterior. All wiring within the door section - heater, switch, and light fixture - is installed by KPS Global in conduit per the National Electrical Code and requires only simple field connection by others for complete operation. Ali components to be U.L. approved. An electrical listing label will be applied to all prewired sections. Service required is 120 volt, 60 cycle, 1-phase. Additional lights, and lighting packages for unit or site application are available. PARTITIONS Common partition walls are available for dual temperature or multi-compartment walk-ins and are attached to adjacent wall panels by the use of cam action locks secured within special sections formed by those panels. SCREEDS A factory provided screed is available for units without prefabricated floor. Depending on application, the screed will be one of the following: (1) Concealed strip screed (2) PVC Channel (3) 1-112" X 1-112" aluminum structural angle (4) 1-112" X 2-112" 18 ga galvanized steel angle PVC channel and aluminum angle meet NSF requirements. An NSF approved coved base can be provided for other screed types. ALTERNATE & OPTIONAL EQUIPMENT — KPS Global can provide an array of pertinent equipment to complete any project and provide a single source installation. (1) Heated Vent: Must be specified for all walk-in freezers operating at a temperature of 32 degrees F. or lower. A heated vent shall be provided to equalize the difference in exterior & interior pressure caused by sudden temperature changes due to opening doors, loading products, & the defrosting of coils. The heated vent shall be located above the freezer door (or located in a side panel, away from the direct air stream flowing from the evaporator). Electrical service required is 120 volt, 60 cycle, 1-phase. (2) Door Window: A 16 112" x 16 112" or 16 112" x 26 112" (viewing area) observation window can be provided in the cold storage doors. Window shall consist of three (3) panes of glass with sealed spaces between them & shall be removable for replacement. Electrical service required is 120 volt, 60 cycle, 1-phase. (Windows may be provided with heaters if required.) SECTION 1/PAGE 4 Due to continuous improvement programs, specifications are subject to change without PULlUe.