Laserfiche WebLink
feet, followed by silty sand to the full depth of the hole. The soil log is presented on <br /> Plate 13. <br /> Discussion of Soil Lithology <br /> Based on the soil observed in the boring, there appears to be good potential for <br /> percolation in the shallow soil zone. Sandy soils generally have a much greater <br /> potential for percolation than fine-grained or cemented soils. However, a percolation <br /> test is the only accepted method for determining the suitability of the soils for a septic <br /> disposal area. Percolation test results are discussed in the following section. <br /> Percolation Test <br /> A shallow percolation test was conducted on the Site. The soil boring discussed above <br /> was used for the percolation test hole. Percolation test procedures conformed to San <br /> Joaquin County Environmental Health Department policy. <br /> Preparation and Presaturation of Percolation Test Holes <br /> After the boring was advanced by hand auger and the soil logged, the test hole was <br /> completed for the percolation testing. Approximately two inches of pea gravel were <br /> placed in the bottom of the open soil boring, followed by a 2.0-inch diameter PVC pipe <br /> with perforations on the bottom. Pea gravel was then used to backfill a few inches of <br /> the annular space. <br /> Live Oak presaturated the percolation test hole approximately 24 hours prior to the <br /> percolation testing. The hole was filled with water to a height of 12 inches above the <br /> bottom of the boring for the presaturation. On the day of testing, the hole was found to <br /> be intact and dry. <br /> Percolation Test Procedure <br /> Live Oak conducted the percolation testing for the boring on May 11, 2020. A standard <br /> four-hour test was selected. Water level measurements were taken every 30 minutes <br /> during this four-hour period. The last 30 minutes of the test were observed by Daria <br /> Afonskaia, Registered Environmental Health Specialist at the San Joaquin County <br /> Environmental Health Department. <br /> An electronic well sounder with a depth accuracy of 1/100th foot was utilized for the <br /> water level measurements. The water level was measured against a fixed reference <br /> point on the well casing. Measurements were recorded on the data sheet in decimal <br /> feet. When necessary after measuring the water level, the hole was refilled with water <br /> to a level of approximately six inches above the bottom of the hole. <br /> LOGE 20-17 Page 6 <br />