Laserfiche WebLink
r. <br /> Tracy High School 7(. �► SXkg <br /> Specifications for Swimming Pool Improvements <br /> Gutter System <br /> INTRODUCTION: \��( <br /> These specifications are for bidding and construction purposes. The contractor shall <br /> thoroughly review the contents herein and bid accordingly. The plans and specifications <br /> provide dimensions and details for the project. (� <br /> Plans and specifications have already been submitted to the San Joaquin County Env. <br /> Health Department and approval will be obtained prior to commencement of work. <br /> PART I - GENERAL <br /> Work under this section is governed by the General Conditions of the Contract. <br /> BACKGROUND: <br /> The Tracy Unified School District desires to improve the competitive swimming <br /> characteristics in addition to providing deeper water in the special use pool (lap pool) at <br /> Tracy High School. The areas of construction include: removing the existing gutter and <br /> skimmer system, installing a stainless steel perimeter gutter system, a surge tank, <br /> complete plumbing, concrete deck work in addition to re-plastering the lap pool at Tracy <br /> High School. NOTE: RE-PLASTERING AND CONCRETE REPLACEMENT WILL <br /> NOT BE PART OF THIS CONTRACT. <br /> DIVISION OF LABOR: <br /> The attached sheet, lists the scope of work for each contract. <br /> GENERAL PROJECT DESCRIPTION <br /> A. General Scope: <br /> 1) Cut and remove the existing pool perimeter gutter and skimmer system. <br /> 2) Cut and remove necessary deck concrete and mechanical room wall to <br /> accommodate new plumbing. <br /> 3) Install new bond beam concrete support if necessary. (Separate line item). <br /> 4) Install new rim-flow stainless steel gutter and grate. <br /> 5) Install new gutter plumbing from the gutter transitions to the new surge tanks <br /> located in the existing pool mechanical room. <br /> 6) Connect plumbing to the existing recirculation pump. <br /> A. Connect return plumbing to the new gutter return system. <br /> B. Install an additional sand filter and re-plumb the filter manifold. <br /> 2 <br />